Advertisement
The amplifier will operate at 120 or 240 volts
50/60 Hz. A separate model is available for
100-volt, 50/60-Hz operation.
ARCHITECTS' AND ENGINEERS'
SPECIFICATIONS
The power amplifier shall be a dual-channel
model of solid-state design employing true
complementary-symmetry output circuitry and
capable of operating from a 100/120/200/220/
240-V, 50/60 Hz ac line. The amplifier shall
contain sensing circuitry to provide protection
for the output transistors against over-
temperature, excessive output voltage, radio-
frequency interference, shorted loads and ex-
cessive output phase shift. The load shall simi-
larly be protected against infrasonic signals,
startup/shutdown transients, low ac line volt-
age, and dc.
Rear-mounted panel controls shall include a
two-position mode switch for selecting between
the dual monophonic mode or the bridged mono-
phonic mode. Input connections for each chan-
nel shall include an octal socket for use with
optional electronic accessory modules, a 3-pin
female XLR-type connector and
jack. Output connectors shall be 5-way binding
posts.
Front panel indicators shall include an illumi-
nated power on/off indicator, individually illumi-
nated protection-circuit-activation indicators
(PROTECT) and clipping indicators (CLIP).
Front panel controls shall include a 31-detent
gain control for each channel and an on/off
switch.
The power amplifier shall meet the following
performance criteria: Maximum input voltage:
7.75 V rms. Input voltage for rated output power
into 4 ohms: 0.775 V rms. Rated output power
per channel: greater than 200 watts into 4 ohms
from 20 Hz to 20 kHz at less than 0.10% THD;
greater than 125 watts per channel into 8 ohms
ELECTRO-VOICE
MANUFACTURING PLANTS AT
© Electro-Voice, Inc. 1995
from 20 Hz to 20 kHz at less than 0.05% THD;
greater than 400 watts into an 8-ohm bridged
load from 20 Hz to 20 kHz at less than 0.10%
THD with channel #1 driven. Voltage amplifica-
tion in dual mode: 31 dB (bridged mode). Hum
and noise: greater than 100 dB (A weighted)
below rated output power. Frequency response:
10 Hz to 50 kHz, +0/–3 dB at any output power
up to rated output power. Damping factor:
greater than 100 at any frequency up to 1 kHz
in dual mode with 8-ohm load.
Intermodulation distortion (SMPTE): less than
0.1% in any mode into 8 ohms. Crosstalk: less
than 70 dB below rated output power. Operat-
ing temperature: up to 50 °C (122 °F) ambient.
Dimensions (H x W x D): 3.5 in. x 19 in. x 16
in. (8.89 cm x 48.26 cm x 40.64 cm). Net weight:
37 lbs (16.8 kg). Color: gray front panel with
black top, bottom, sides and rear with white
nomenclature.
The power amplifier shall be the Electro-Voice
7200.
UNIFORM LIMITED WARRANTY
Electro-Voice products are guaranteed against
1
/
-inch phone
4
malfunction due to defects in materials or work-
manship for a specified period, as noted in the
individual product-line statement(s) below, or in
the individual product data sheet or owner's
manual, beginning with the date of original
purchase. If such malfunction occurs during the
specified period, the product will be repaired or
replaced (at our option) without charge. The
product will be returned to the customer pre-
paid. Exclusions and Limitations: The Lim-
ited Warranty does not apply to: (a) exterior
finish or appearance; (b) certain specific items
described in the individual product-line
statement(s) below, or in the individual product
data sheet or owner's manual; (c) malfunction
resulting from use or operation of the product
other than as specified in the product data
sheet or owner's manual; (d) malfunction re-
a MARK IV company
BUCHANAN, MI
Litho in U.S.A.
600 Cecil Street, Buchanan, Michigan 49107
NEWPORT, TN
SEVIERVILLE, TN
sulting from misuse or abuse of the product; or
(e) malfunction occurring at any time after re-
pairs have been made to the product by anyone
other than Electro-Voice or any of its authorized
service representatives. Obtaining Warranty
Service: To obtain warranty service, a cus-
tomer must deliver the product, prepaid, to
Electro-Voice or any of its authorized service
representatives together with proof of purchase
of the product in the form of a bill of sale or
receipted invoice. A list of authorized service
representatives is available from Electro-Voice
at 600 Cecil Street, Buchanan, MI 49107 (616/
695-6831 or 800/234-6831). Incidental and
Consequential Damages Excluded: Product
repair or replacement and return to the cus-
tomer are the only remedies provided to the
customer. Electro-Voice shall not be liable for
any incidental or consequential damages in-
cluding, without limitation, injury to persons or
property or loss of use. Some states do not
allow the exclusion or limitation of incidental or
consequential damages so the above limitation
or exclusion may not apply to you. Other Rights:
This warranty gives you specific legal rights,
and you may also have other rights which vary
from state to state.
Electro-Voice Electronics are guaranteed
against malfunction due to defects in materials
or workmanship for a period of three (3) years
from the date of original purchase. Additional
details are included in the Uniform Limited
Warranty statement.
Service and repair address for this product:
Electro-Voice, Inc., 600 Cecil Street, Buchanan,
Michigan 49107 (616/695-6831 or 800/234-
6831).
Specifications subject to change without no-
tice.
OKLAHOMA CITY, OK
GANANOQUE, ONT.
Part Number 532233—9511
Advertisement
