Table Of Contents - SPL 2490 Manual

Fade In .............................................................................................
Signal Flow .......................................................................................
Control Surface ................................................................................
The Sections In Detail ......................................................................
Sources and Input ...........................................................................
Pre and Post Insert Trims, Insert, Monitor Section
Master Faders, Speakers .................................................................
Before you operate your DMC, fi rst check carefully whether the local voltage
setting corresponds to the setting on the external transformer!
Before switching on external transformer and DMC, the DMC must be
connected to the external transformer with the suppiled multicore lead. Pay
attention to a secure connection.
The DMC and the external transformer should be situated away from heat
sources and direct sunlight. DMC and transformer need suffi cient air circu-
lation. Avoid installation in environments exposed to vibrations, dust, heat,
cold, moisture or electrical and magnetic fi elds.
Do not install the unit in proximity to power amplifi ers or digital processors.
You may consider placing it near other analog gear. Such placement can
prevent interference from Word Clock, MIDI, etc.
4 Option: MasterBay
5 Rear Panel
6 Measurements
Specifi cations
7
7
Power Supply
............................ 8
9
Warranty
• Do not open the case. You may risk severe electric shock and may damage
your equipment.
• Leave repairs and maintenance to a qualifi ed service technician. Should
foreign objects fall inside the case, contact your authorized dealer or
support person.
• To avoid electric shock or fi re hazards do not expose the unit to rain or
dampness.
• In case of lightning unplug the power supply.
• Never force a switch or knob.
• To clean the case use a lint-free cloth. Avoid cleaning agents as they may
damage the fi nish, use an acid-free cleaning oil instead.
• Please support the back of the unit when it is being mounted.
..........................................................................
.......................................................................................
................................................................................
.................................................................................
..................................................................................
.........................................................................................
Contents
10
11
12
18
19
20
Installation/Security Advices
3