Installing The Optional Cinewide/Autoscope Lens Motor; Remove Projector Front Feet - video xtreme VX-22d Owner's Operating Manual

Installation
3.5
Installing the Optional
CineWide/AutoScope
Lens Motor
Remove Projector Front
Caution
7. Lock the lens in place by turning the
Lens Locking Nut (to the left of the lens)
180 degrees counter-clockwise. (Use a
6.0mm hex wrench.)
8. Replace the Lens Cavity Front Cover.
9. Reattach the Projector Front Jewelry by sliding the top down onto the two retaining
dowels. Tighten the Phillips screw at the top of the projector to secure it.
10. Remove the Front Lens Cap.
If you are installing a VX-22d with the optional CineWide with AutoScope system, proceed
as follows to install the AutoScope lens motor.
Note
➤
Place the projector upside down on a
Feet blanket or other soft surface. Loosen and
remove the two front feet on the projector.
Make sure to route the wire harness in its original position and away
from the moving lens stages and Motor Assembly, to prevent
unexpected disconnection or lens damage.
1. Do not install the CineWide lens yet, only the lens motor. You will
install the CineWide lens after you install the projector and adjust
the primary lens.
2. Some components shipped with your projector may differ slightly
from what is shown in these instructions.
3. The anamorphic lens mounting kit is partially pre-assembled at
the factory – the AutoScope lens motor and lens mounting
assemblies are both fully assembled.
24
Remove
Runco VX-22d Owner's Operating Manual