Specifications; Wiring Configurations - Rockford Fosgate Prime R2D2-10 Installation & Operation Manual

S
PECIFICATIONS
PRIME R2-DVC
Nominal Impedance (ohms)
Frequency Response (Hz)
Voice Coil Diameter - inch
(mm)
Displacement - cu. ft.
(Liter)
Fs - Free Air Resonance (Hz)
Qts
Vas - cu. ft.
(Liter)
Xmax - inch
(mm)
SPL (dB @ 1w/1m)
Power Handling-Watts (RMS)
(Peak)
By varying the wiring configuration of your speakers you can create an
impedance load to match your system. Altering the wiring configurations
gives a range of options for impedance loads. Series, Parallel, or
Series-Parallel wiring configurations are different techniques for wiring
speakers that provide different loads. Series configuration is a string
method where speakers are wired end to end. Parallel configuration
uses two or more speakers wired across common terminals.
Series-Parallel configuration combines both techniques. Choose the
wiring diagram that corresponds to the number of woofers and the
impedance of your amplifier.
10"
R2D2-10 / R2D4-10
2 x 2 / 2 x 4
45-250
2 (4-Layer)
(51)
0.101
(2.85)
35
0.47 / 0.53
1.38
(39.0)
0.256 / 0.236
(6.5 / 6.0)
89
250
500
W C
IRING ONFIGURATIONS
SUBWOOFER CROSSOVERS
There are two operational types of crossovers, passive and active.
Passive crossovers (coils or inductors) are placed on the speaker
leads between the amplifier and speaker. An active crossover is an
electronic filter that separates the audio signal fed to different
amplifiers. For optimum subwoofer performance, we recommend
using an active 80-100Hz low-pass crossover at 12dB/octave.
5
12"
R2D2-12 / R2D4-12
2 x 2 / 2 x 4
43-250
2 (4-Layer)
(51)
0.150
(4.25)
35
0.60
2.34 / 2.43
(66.4 / 68.8)
0.256 / 0.236
(6.5 / 6.0)
87
250
500
Specifications subject to change without notice