Yealink SIP-T48G Quick Installation Manual

1. Press the key when the phone is idle to obtain the IP address of the phone.
2. Open the web browser on your computer, enter the IP address into the address bar (e.g.,
"http://192.168.0.10" or "192.168.0.10") and then press the
3. Enter the user name (default: admin) and password (default: admin) in the login page
and click .
Click on ->
You can configure the network settings in the following ways:
: By default, the phone attempts to contact a DHCP server in your network to obtain its valid
network settings, e.g., IP address, subnet mask, gateway address and DNS address.
: If your phone can not contact a DHCP server for any reason, you need to
configure the IP address, subnet mask, gateway address, primary DNS address and
secondary DNS address for the phone manually.
: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE
mode. Contact the ITSP for the PPPoE user name and password.
The wrong network settings may result in the inaccessibility of your phone and may have an impact on
the network performance. Contact your system administrator for more information.
Click on ->
It shows the register status of the current account.
Register Status:
You can select Enabled/Disabled to enable/disable the account.
Line Active:
It is shown on the touch screen to identify the account.
Label:
It is shown as caller ID when placing a call.
Display Name:
It is provided by ITSP for registration (required).
User Name:
It is an authenticated ID for authentication provided by ITSP (required).
Register Name:
It is provided by ITSP for registration (required).
Password:
It is provided by ITSP for registration (required).
Server Host:
(Green) Registered (Gray)
Check with your system administrator if any error appears during the registration process or a specific
configuration is required for your registration.
When the phone is idle, tap ->
to configure the network.
When the phone is idle, tap ->
For more information on account parameters, refer to
For more information, refer to the User Guide available online:
c
Copyright 2014 YEALINK NETWORK TECHNOLOGY CO.,LTD.
key.
->
-> (X=1,2,3,4,5,6)
Register Failed (Green and Flashing)
-> ->
-> to configure the account.
.
Registering
www.yealink.com
(V72.4)
Applies to firmware version 72.1 or later.