Operating Instructions; Cleaning Instructions - Nesco FS-130 Care/Use Manual

1. Place the unit on a flat and stable work surface.
2. Be sure unit is fully cleaned and assembled.
3. Do not operate the appliance continuously for more than 10 minutes, if you do
operate longer allow the appliance to cool for 30 minutes before second operation.
4. Make sure the Switch is in the "OFF or OUT" position. Always reach switch
by entering from the back of the unit, keeping hands away from blade.
5. Insert plug into standard 120 Volt electrical outlet, rated 15A minimum.
6. Place a suitable tray or plate behind slicer to collect the sliced food.
7. Place food on Food Carriage, between the Support Plate and Slicing Guard. To
avoid risk of injury, always use Food Carriage and Slicing Guard while cutting.
8. Set the Thickness Adjustment Knob to the desired thickness to be sliced.
9. Start the Motor Assembly by sliding the Safety Lock and pressing the switch
button ON or IN. The safety lock prevents accidental engagement.
10. Grasp the Slicing Guard with one hand and gently push food into Support
Plate while sliding Food Carriage towards Blade. When food has cleared
Blade slide Food Carriage back to starting position. IMPORTANT - NEVER
PUT YOUR FINGERS INTO THE BLADE WHILE UNIT IS OPERATING
OR PLUGGED INTO ELECTRICAL OUTLET.
11. To avoid injury wait until the blade has stopped moving before cleaning.
12. When you have finished slicing food, press Switch to "OFF or OUT", unplug
from electrical outlet and follow cleaning instructions.
13. For safety, adjust slicer thickness to "0" setting to protect blade edge.
1. Always unplug the appliance before cleaning.
2. Never immerse the Motor Assembly of this appliance in water or other liquid.
3. The Blade and Slicing Guard can be hand washed in warm soapy water. Be
careful when cleaning the Blade as it is extremely sharp. Do not leave blade
under water; trying to handle sharp objects in water is hazardous.
4. Set Thickness Adjustment Knob to "0" by turning full counter-clockwise.
5. For ease of cleaning, the Food Carriage can be tilted up (Fig 2)
6. Remove Blade by holding with one hand, flip tab out and turn to unlock Blade
Locking Screw by turning it clockwise. CAREFULLY pull Blade off and hold
by using the center part of Blade (Fig. 3).
7. Clean outer surface of Motor Assembly with a damp cloth. Never immerse
Motor Assembly in water or any other liquid. Do not use steel wool, abrasive
cleaners or sharp utensils.
8. After cleaning and drying, install blade to Motor Assembly in reverse order
of Step 6. Carefully place Blade onto front opening of Motor Assembly.
Insert the blade onto hub of base assembly and turn counter-clockwise. Use
tab to tighten and lock Blade in place.

OPERATING INSTRUCTIONS

CLEANING INSTRUCTIONS

4