Input Management Parameters - inout S-01 User Manual

5.7 Input management parameters

The playing of the files takes place by activating the available logical inputs, the activation
modes are set through the TPCM, MICP and MIRS parameters inserted in the
configuration files.
Mnemonic Description of timing parameter
Setting the persistence time of the input command (time to wait before Security
Player is able to interpret the input command) expressed in decimals of
milliseconds (value between 0 and 255 in decimal).
0 = no delay
TPCM
1 =10mSeconds
(DEFAULT=10)
2 =20mSeconds
100 = 1 second
200 = 2 seconds
250 = 2,5 seconds (max. value)
Setting Mode Input Continuous Play
0 = having terminated the playing of the codified file, requested from the input code,
MICP
Security Player goes in standby.
(DEFAULT=1)
1 = the requested codified file is continuously played until the relevant input code is
inserted.
Setting Mode Input ReStart
0 = repeated activation or deactivating of the same input code does not influence
the playing of the relevant file. Only the activation of a different code can block
MIRS
the playing underway and activate the playing of the new requested file.
(DEFAULT=0)
1 = in the moment in which an input code is enabled the playing of the of the
relevant file from its beginning takes place, even if it is already in play.
Setting Input Management Mode
IMOD
0 = active-high input mode or with contact normally open.
(DEFAULT=1)
1 = active-low input mode or with contact normally closed.
User manual S-01 v.
1.3
Pag. 10