Daewoo DRVT-40 Instruction Manual page 32

DTBC-MNF(or D)1NP-AG 2007.9.11 4:18 PM ˘ ` 31
Digital Audio
1
Press [SETUP].
2
Use [œ/√] to select 'Preferences'.
3
Whilst 'Preferences' is selected, press [†] to
select 'Digital Audio'.
4
Use [œ/√] to select the desired digital output
type.
5
Press [SETUP] to exit the menu.
• Off
No signal will be output from the Digital Audio Out
jacks.
• PCM
Select when connected to a 2 channel digital stereo
amplifier. The DVB-T VCR/DVD Recorder's digital
audio signal will be output in the PCM 2ch (Pulse
Code Modulation 2 Channel) format when you play
a DVD recorded with a Dolby Digital (only for DVD)
or MPEG soundtrack. If the DVD is recorded with a
DTS (Digital Theatre Surround) sound track then no
sound will be heard.
• Bitstream
If your DVD is recorded with a DTS sound track then
select Bitstream when connected to a Dolby Digital
or DTS decoder (or an amplifier or other equipment
with a Dolby Digital or DTS decoder).
Video Output
Progressive Scan Video provides the highest picture
quality with reduced flickering.
RGB :
If the DVB-T VCR/DVD Recorder is in RGB
mode, you can watch RGB signal by connecting the
recorder to an analogue television using the SCART
jacks.
Interlace (576i, 1080i) or Progressive (576p, 720p) :
If you connect the DVB-T VCR/DVD Recorder to a
digital television (DTV) or Monitor using the
COMPONENT jacks, set Video Output to '576i',
'576p' '1080i' or '720p' (i : Interlaced scan mode, p :
Progressive scan mode).
1
Press [SETUP].
2
Use [œ/√] to select 'Preferences'.
3
While 'Preferences' is selected, press [†] to
select 'Video Output'.
4
Use [œ/√] to select the desired Video Output
mode.
5
Press [SETUP] to exit the menu.
When you use the HDMI connection, you can
change the resolution (576i, 576p, 720p, 1080i) for
the HDMI output by setting the video output option
in setup menu.
Setup menu
31