OPERATING INSTRUCTIONS Discovery™ Portable LED Light System 1. Components Check to see that the following components are included in the packaging: 1. Battery Pack This unit contains an integrated Lithium Ion battery, an on/off control button (1), and a light intensity control button (2).
The figure to the right shows the filter installed (8) over a headlight. 2. Zeon Discovery Controls and Connectors 1. On/Off Control Button (1) Turns the LED on and off. 2. Light Intensity Control Button (2) Adjusts light output between three intensity settings;...
3. Charge The Battery The Zeon Discovery battery is not completely charged on delivery. The battery must be charged for at least 3 hours before its first use. Beyond the initial charge, no battery conditioning is required.
OPERATING INSTRUCTIONS Discovery™ Portable LED Light System 4. Operate the Zeon Discovery Lighting System 1. A ttach the LED headlight to your loupe (1) by tightening the jaws of the mounting hinge to the mounting block on the bridge of your loupe frame. (You may have to first attach the mounting block to your loupe frame if it is not already attached.)
OPERATING INSTRUCTIONS Discovery™ Portable LED Light System 9. Install the curing filter (if needed). a) Slide the filter’s frame over the outer rib of the headlight so that the hinged frame can flip down in front of the headlight as shown in the figure to the right.
6. Safety Precautions/Warnings 1. O nly Orascoptic–supplied power supplies (part number AL-DISCOVERY-CHG) are to be used to power the Zeon Discovery LED battery. 2. In order to avoid the risk of permanent eye damage, do not look directly into the headlight or aim the headlight directly into someone’s eyes. Consider providing patients with protective eyewear.
But, it is inevitable that at some time in the future you will need to dispose of it. When that time comes, we encourage you to return it to Orascoptic in its original packaging for environmentally sound recycling. Orascoptic will be glad to bear the cost of the return shipping.
(such as a power outage). 4. The charger display stays red (even Send the lighting system with the charger to after 3 hours of charging) and does not Kerr Corporation/Orascoptic for evaluation. change to green. 5. Battery capacity monitor is blinking. - Battery capacity has been depleted.
OPERATING INSTRUCTIONS Discovery™ Portable LED Light System 10. Replacement Parts AL-DISCOVERY-BAT Zeon Discovery battery pack AL-DISCOVERY-CAB Zeon Discovery cable with headlight AL-LCFZZ-DIS-1-AL Zeon Discovery complete curing filter AL-DISCOVERY-CHG Zeon Discovery universal charger 11. Limited Manufacturer’s Warranty This limited manufacturer warranty from Kerr Corporation applies for all countries to the extent that no other warranty exists at that location. Pursuant to the following contractual provisions, Kerr Corporation guarantees material, construction and design to be free of deficiencies from the time of first purchase.
Page 12
OPERATING INSTRUCTIONS Discovery™ Portable LED Light System 7. This limited warranty does not apply to abnormal signs of use. In addition, this limited warranty does not apply if a) The deficiency has been caused by misuse of the instructions for operation, inappropriate use, contact with fluids or moisture or extreme heat or climatic conditions and/or short term variations in relevant influences or to corrosion, oxidation, unauthorized intervention or attempts at connection, unauthorized opening or repair,...
Need help?
Do you have a question about the Zeon Discovery and is the answer not in the manual?
Questions and answers