Using The Battery Case; Uninstalling The Battery Case - OtterBox defender User Manual

Using the Battery Case

1. To charge the Battery Case, use the included micro-USB cable and connect the
case to a USB power source (e.g. a computer or USB wall-outlet).
2. After the case is fully charged, connect the iPhone to the battery case by aligning
the charging port of the phone with the protruding lightning connector built into the
base of the battery case. Then gently slide the iPhone downwards until the iPhone
sits firmly on the lightning connector of the case.
3. After the iPhone is firmly attached to the battery case, attach the top protective
piece by sliding it down over the top of the phone. (Make sure to gently press down
to ensure the top piece is flush against the battery case and the iPhone).
4. The case should being to charge automatically, if it does not, PRESS and HOLD
the "On / Off" button located on the back of the extended battery case for three (3)
seconds. The battery case should now begin charging the iPhone. This same
procedure can toggle the case on or off.
5. While the DEFENDER is charging the iPhone, a bolt (when < less than 100%
power) or a plug (at 100% power) icon will be displayed at the top right corner of
the iPhone screen.
6. To check the power remaining inside the case simply PRESS the ON / OFF
button once and the LED bar will light up for 3 seconds and show the amount or
remaining power contained in the case. The "longer" the LED bar is, the more
power is remaining in the case. A full bar would represent a fully-powered case.
Note 1: A blue light will flash on the LED display on the back of the DEFENDER to
indicate that the battery case is correctly charging.
Note 2: When the iPhone is secured within the case the sequence of charging via
the micro-USB is as follows. The iPhone will charge first, followed by the case.

Uninstalling the Battery Case

Located near the top left corner of the battery case there will be a small indentation
between the protective bumper and extended battery component.
Gently separate the protective frame from the extended battery by placing a
fingertip in the indentation and pulling upwards gently.