Smarthome EM 1000 User Manual

Echoport wireless asset protection

Advertisement

Quick Links

SMARTHOME.COM(TM) 1-800-SMART-HOME
949-221-9200 http://www.smarthome.com

Advertisement

Table of Contents
loading

Summary of Contents for Smarthome EM 1000

  • Page 1 EM 1000 User’ s Manual Wireless Asset Protection ECHOPORT SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 2: Radio And Television Interference

    If this occurs, you may want to contact your hearing aid manufacturer to consider alternatives. Other Medical Devices - If you are using any other personal medical device, consult the manufacturer and ask if there is proper shielding from RF radiation. SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 3: Damaged Antennas

    , Vehicles Equipped with Airbags gnat place portable wireless units in the deployment area of air bags. Air bags deploy with great force; if equipment is placed improperly in the wrong areas, seri- ous injury may occur. SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 4 Anytime you replace the batteries, be sure to reprogram the current security code to the remote control so the sensor alarm will recognize the remote signals (see Remote Control, page 14). SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 5: Low Battery Message

    Note: The two supplied mounting screws are suitable for mounting the sensor alarm’ s main unit on a wooden surface. If mounting the main unit on drywall, masonry, or another type of surface, use the appropriate mounting hardware (not supplied). SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 6 Note: If you don’ t press a button for about 30 seconds, the sensor alarm beeps, the PROG indicator turns off automatically, and (if you have not completed Step 4) the sen- sor alarm does not recognize the remote signals. Start over at Step 1. SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 7 You can now register device. Enter the 15-digit serial number located on the back of vour unit. then hit “ Continue.” SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 8: Service Plans

    If the test was successful, you will receive a notification via your specified notifica- tion methods (see Registering Your Device on the Website, pages 9-10). You can check all test messages on your device Activity Log online at www.echoport.com. SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 9 Unauthorized Access The unit prevents unauthorized remote access. If it detects an attempt at authorized access by other remote or other RF devices, it will emit a short chirping noise. SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 10: Operating Your

    A to side B and increasing power transmission level until service is found. This search can take up to four minutes if the unit needs to operate at high-power mode to find adequate service. SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 11 30 seconds, the alarm will be activated; this entry delay is available only in SIREN mode. To disarm the unit, enter your security code using the keypad on the main unit. SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 12: Using The Remote

    This may be done when the unit is armed or disarmed. When the PANIC button is pressed, a main alarm will immediately be transmitted. If the main unit is in SIREN mode, the audible alarm will also sound. SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 13 Once the unit is armed, if the auxiliary device is opened (or closed if the device was open during power on), the auxiliary alarm will be activated. The auxiliary alarm operates in the same manner as the main alarm once it is activated. SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 14 Code 4 = Low Battery Alert or first 10 dlgils of device serial number) *If you are using a numeric pager as a notification method, we recommend assigning an easy-to-remember 4-digit device number when setting up your pager notification. SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 15 Double check the pager number and paging provider you selected at EchoPort Central TM Check EchoPort Central TM system status. Check the status of your paging provider. Service delays among paging providers are not uncommon, especially during peak business hours. Continued on page 18 SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com...
  • Page 16 SS7 (Signaling System 7) networks. The Aeris.net hub identifies EchoPort, Inc.‘ ” as the service provider and routes the data for delivery via a dedicated back-end link. SMARTHOME.COM(TM) 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com _ -__~~.___~___~ - ~ _ __ ___~ _...

Table of Contents