Table of Contents
Advertisement
Maintenance and troubleshooting
Maintenance and troubleshooting
CAUTION: System power
Always turn the radar system OFF before carrying out any
routine maintenance on the scanner or nearby equipment.
Introduction
DO NOT remove the rear cover of the multi-function display or the
external cover of the Digital Radome scanner. There are no user serviceable
parts or adjustments. DO NOT attempt to service the equipment.
Maintenance
Maintenance is limited to the following periodical checks:
•
Examine the cables for signs of damage, such as chafing, nicks and
cuts. If the connector is showing signs of corrosion, lightly grease the
threads of the connector with "Renolit Aqua 2 Calcium" grease.
•
Check that the cable connectors are firmly attached.
•
Make sure the scanner is still securely attached to the mounting
surface.
•
Once a year, remove, grease and re-attach the mounting bolts securing
the scanner.
Troubleshooting
The following table will help you identify the most likely cause of a
problem, and the corrective action required to restore normal operation.
Problem
"No Data" or "No Scanner"
message
The bearing displayed on the
multi-function display is not
the same as the actual
bearing.
Possible causes and solution
1. Check that the cable connecting the
Digital Radome scanner to the multi-
function display unit is firmly attached
and undamaged.
2. Check relevant scanner fuses and
breakers.
3. Check that the power source is of the
correct voltage and sufficient current.
4. Software mismatch between equip-
ment may prevent communication.
Contact Raymarine technical support.
hs
If using a SeaTalk
Switch:
5. Check that all radar scanners are
correctly connected to the SeaTalk
switch.
6. Check the status of the SeaTalk
switch.
hs
7. Check that SeaTalk
cables are free
from damage.
Perform the bearing alignment proce-
dure described in the installation guide
for the relevant multi-function display
unit.
17
hs
hs
Hide quick links:
Advertisement
Table of Contents
