Performing A Full Display Check - Accu-Chek Active User Manual

6.4 Performing a full display check

longer than 3 seconds
96
015134 AccuChek Active_Eng.indd 96-97
The standard power-on display test checks the most important
display elements. To verify that all of the elements are functioning
correctly, you can carry out a full test.
Press and hold down the M and S buttons together for longer
than 3 seconds.
All the elements of the liquid crystal display (LCD) are shown
at once. Either "mg/dL" or "mmol/L" will be visible depending
on the country-specific setting.
Press any key to terminate the display test and turn off your
Accu-Chek Active monitor. If you do not press a key, the monitor
will shut off automatically after about 2 minutes.
97
12.08.2004, 14:54:41