Advertisement
5
Secure the Guylines
• Attach and stake out guylines. (Fig. 9)
Fig. 9
7
Disassembly
• Remove the power cord plug from Energy Pack and detach
Energy Pack from the shelter leg.
• Wrap the power cord around the power cord holder and
secure the plug. (Fig. 11)
• Remove stakes and guylines.
• Lower the frame one post at a time by pressing the push
button locks located on lower portion of posts. (Fig. 13)
• Remove the shelter top from frame and fold for storage.
• Press the push buttons found at upper corners of the
frame. (Fig. 14) Collapse shelter frame and store in
carry case.
Push
Button
Fig. 13
Things You should Know:
• Under certain conditions (cold weather, high humidity,
etc.) condensation will form on the inside of your shelter.
Condensation is caused by water vapor from your breath,
perspiration, or any wet clothing inside the shelter. It is NOT
LEAKAGE through the shelter fabric.
• Tree limbs, tree sap, bird droppings, or moisture steadily dripping
off tree limbs can cause damage to the shelter fabric and its
coating resulting in leaks or loss of flame-resistant properties.
• Never store shelter, even for a short period of time, without drying
it thoroughly and brushing off caked dirt. Do not pack stakes
inside your shelter. Use a separate storage bag.
• Stakes should be removed by pulling on the stake itself. NEVER
PULL ON THE SHELTER TO REMOVE STAKES AS THIS COULD
RESULT IN PROPERTY DAMAGE OR PERSONAL INJURY.
• Do not leave your shelter set-up for weeks at a time. Be aware
that exposure to ultraviolet rays from the sun can seriously
damage material and/or cause it to become discolored.
• This product is not intended to be used during heavy rain, wind,
hail, snow or other inclement weather. Excess water build-up
can cause the frame system to be come unstable, and possibly
collapse, causing injury.
Guyline
Push
Fig. 14
Button
6
Install the Shelter Lighting
Energy Pack
• Align tabs on the Energy Pack with the shelter leg, and
attach the Energy Pack to the shelter leg. (Fig. 10)
• Remove power cord plug from its holder, and plug it into
the Energy Pack. (Fig. 11)
• Rotate the switch on the Energy Pack to adjust the
lighting. (Fig. 12)
Note: Additional details concerning the shelter lighting
system can be found in the instruction sheet packed with
the Energy Pack.
Tabs
Energy
Fig. 10
Fig. 10
Pack
Power
Cord
Switch
Energy
Pack
Fig. 12
8
To Store
1. Place the Energy Pack in its carry case.
2. All stakes must be placed in the storage bag to prevent
damage to the fabric items placed in the carry case.
3. Make sure all components are clean and dry before
placing in carry case.
4. Store in a clean, dry area.
• The shelter top, screen, and sun wall (if included) should be
carefully removed during windy conditions to avoid damage to
product or personal injury.
• DO NOT use gas or flame sources under or near this product.
WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM
THIS TENT FABRIC.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
The Coleman Company, Inc. • 3600 North Hydraulic • Wichita, Kansas 67219 U.S.A.
1-800-835-3278 • www.coleman.com
MADE IN CHINA
© 2010 The Coleman Company, Inc. All rights reserved.
Coleman
,
, and
®
The Coleman Company, Inc.
Power
Power
Cord
Cord
Plug
Holder
Fig. 11
are registered trademarks of
4010009477 (ECN20014620-02)
Advertisement
