Coleman STITCHLINE 2000007831 Setup Instructions

Before you begin
Read all instructions before set up.
Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
Do not set up your tent under trees because of potential lightning
strikes or falling tree limbs in inclement weather.
Secure with all stakes and guylines provided to prevent property
damage or personal injury.
For best results in windy conditions, position narrow end of tent
into the wind.
Do not drop tent.
Do not bounce tent bag on its end to remove tent, as these
actions may damage the frame.
THIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO
PEOPLE TO ASSEMBLE.
Under no circumstances should this product be used to cover
automobiles, marine products or similar items.
CAUTION: Avoid pinch points when opening and closing the
tent frame.
Description Repair Kit
Plastic Clip 16 mm
5010000845
Plastic Clip 20 mm
5010000846
Fabric Repair Kit
5010000852
1
Extend the Tent Frame
Stand the tent upright with the hub assembly at the
top. (Fig. 1)
Unfold the arms of the tent downward until they lay flat on
the ground. (Fig. 2)
Fig. 1
2
Raise the Tent
Unfold the arm joints located at each of the tent corners.
The tent will raise as the leg poles are extended.
(Fig. 3 and 4)
Extend each of the telescoping leg poles until they snap
into place. (Fig. 5 and 6)
TENT SETUP INSTRUCTIONS
Description Repair Kit
5010000851
Plastic Corner Joint
5010000856
Fabric Joint Cover
Fig. 2
Fig. 4
Fig. 3
MODEL 2000007831
Fig. 5
3
Verify Connections
between Tent and
Frame Poles
Verify the clips along the edges of the tent are properly
attached to the frame poles. (Fig. 7 and Fig. 8)
Fig. 7
Clip
Fig. 8
Fig. 6
Pole
(continued on other side)