Clock; Compass Calibration Procedure - Chevrolet Captiva 2014 Owner's Manual

5-6 Instruments and Controls
note pad holder, or any other
magnetic item. Turn off the vehicle,
move the magnetic item, then turn
on the vehicle and calibrate the
compass.
To calibrate the compass, use the
following procedure:

Compass Calibration Procedure

1. Before calibrating the compass,
make sure the compass is set to
the variance zone in which the
vehicle is located. See
Compass Variance (Zone)
Procedure earlier in this
section.
Do not operate any switches
such as window, sunroof,
climate controls, seats, etc.
during the calibration procedure.
2. Press the vehicle information
button until PRESS
CALIBRATE COMPASS
displays.
3. Press the set/reset button to
start the compass calibration.
4. The DIC will display
CALIBRATING COMPASS:
TURN IN CIRCLES. Drive the
vehicle in tight circles at less
than 8 km/h (5 mph) to complete
the calibration. The DIC will
display COMPASS
CALIBRATION COMPLETE for a
few seconds when the
calibration is complete. The DIC
display will then return to the
previous menu.

Clock

To set the time and date:
1. Turn the ignition key to ACC/
ACCESSORY or ON/RUN.
Press
2. Press
and YYYY (hour, minute, month,
day, and year) display.
TO
3. Press the softkey below any one
of the tabs to be changed.
to turn the radio on.
and HR, MIN, MM, DD,
4. To increase the time or date do
one of the following:
Press the softkey below the
selected tab.
Press SEEK, or
Turn clockwise.
5. To decrease the time or date do
one of the following:
Press SEEK or
Turn counterclockwise.
The date does not automatically
display. To see the date press
while the radio is on. The date with
display times out after a few
seconds and goes back to the
normal radio and time display.
FWD.
REV.