Advertisement
PREPARATION:
Rope Twist shower walls are to be installed directly over stud walls. Drywall is not required.
A) Remove dry wall surface and ensure that alcove is plumb and square. (Illustration 1)
B) The studs should be located as shown to properly support walls. Provide additional studs where
illustrated below. (Illustration 2)
8"
(203mm)
See
View
"A"
C) Rough plumbing and fittings must be installed before walls.
NOTE: Installation over greenboard or firewalls: If installing wall panels over greenboard and/or firewall material, and not
directly on the studs, your alcove dimensions must consider the thickness of this material. Measure from the inside of the
finished walls.
Illustration 1
60-3/16"
(1529mm)
9"
(229mm)
2 x 4 Installed for optional shower door installation
4'
(1219mm)
Each alcove
stud must
be plumb
and square.
9"
(229mm)
View "A"
Typical at BOTH ends
NOTE: Notch cross
support as needed
to allow for piping.
2
Illustration 2
8"
(203mm)
8-1/4" REF
(210mm)
6"
(152mm)
See
View
"A"
7 5 3 8 4 6 - 1 0 0 R e v . C
12"
(305mm)
32"
(813mm)
Advertisement
