Door Adjustments - Blodgett Combi BC14E Service And Repair Manual

DOOR ADJUSTMENTS

NOTE: When making door adjustments, always
adjust the hinge side first.
1. Swing the door so it just hits or runs into the catch
on the left hand side of the door. DO NOT latch the
door handle to the catch on the oven body. The
left hand side of the door should just be touching
the gasket evenly from top to bottom.
Adjusting the Hinges
NOTE: If you need to adjust the hinges, always ad-
just the top hinge first.
NOTE: The hinges on the door have no adjustment,
you can only adjust the hinge on the oven.
1. Adjust the top hinge as follows:
A.) Loosen the three allen head bolts on the
top hinge attached to the oven.
B.) Tap the hinge in or out as needed. Keep the
hinges parallel as shown in FIGURE 4C.
C.) Tighten the three allen head bolts
2. Adjust the bottom hinge as follows:
A.) You must remove the weight of the door
from the bottom hinge to adjust it. To re-
move the weight from the hinge, slide a
screwdriver head into the gap where the
two top hinges touch and pivot. Lift up the
door slightly.
A.) Loosen the three allen head bolts on the
bottom hinge attached to the oven.
B
A
B.) Tap the hinge in or out as needed. Keep the
hinges parallel as shown in FIGURE 4C.
C.) Tighten the three allen head bolts.
D.) Remove the screwdriver to lower the door.
Adjusting the Catch
Adjust the catch as follows:
1. In the top of the door handle is a round roller.
Swing the door until the door handle is close
to the catch on the oven.
2. Loosen the two bolts holding the latch to the
face of the appliance.
3. Adjust the catch from side to side until the
head of the catch is centered with the roller.
4. Adjust the catch up and down. There should
be a small clearance between the wheel on the
door handle and the tooth of the catch on the
oven. See FIGURE 5. In most cases the catch
will be all the way up.
5. Tighten the two bolts that hold the catch in
place.
6. For easy alignment, swing the door close to the
catch. Use a felt tipped marker on the door
handle to mark the catch position.
7. Adjust the top of the catch in and out. Adjust the
top of the catch so that the door closes firmly.
8. Tighten the single catch bolt.
FIGURE 4
1---6
INSTALLATION
Door
C
Oven