Accessory Cabinet - Kenwood TKR-750 Service Manual

Note :
Relationship between TEST/SPKR connector (15-pin) con-
nection and speaker output.
When pins 9 and 12 are shorted : Built-in internal speaker
is used.
When pins 9 and 12 are open and output is from pins 6 and
12 : KES-4 or KES-5 is used.
Fig. 4-1
Fig. 4-2
Fig. 4-3
INSTALLATION

4. Accessory Cabinet

You can install optional accessories, such as a DC power
supply or duplexers in the accessory cabinet.
1. Place the optional accessory in the cabinet as shown be-
low.
2. If necessary, attach cushions (G13-1801-04 and/or G13-
1802-04) to the top plate (J21-8402-04) in order to adjust
the space between the cabinet and the top plate. Then,
insert the 3 tabs of the plate into the slots in the side of the
cabinet. High, middle, or low positions are available. To
afix the plate, inset and tighten 2 screws on the other side
of the plate.
You can also flip the top plate upside-down to adjust a
height of the cabinet space.
Cushion
(G13-1801-04 or
G13-1802-04)
The top plate can be inverted to adjust the height
of the cabinet space.
TKR-750
Hardware fixture
Tighten screws
or
Fig. 5
Insert the plate
tabs to set the
height position
(high, middle,
or low).
7