Topfield CRC-2400 User Manual page 77

72 Universal Remote Control
1. Turn on the device you want to operate.
2. Point the remote control at the remote sensor on the de-
vice.
3. Hold down the
for two seconds until the light flashes on. For example,
if you want to operate your television with the remote
control, press the
£
¢
4. Press the
CHANNEL
vice turns off.
If you want to find out the number which you set for your de-
vice, do as follows:
1. Hold down the
for two seconds. For example, if you want to know the
number which you set for your television, press the
£
¢ ¡
and buttons simultaneously.
TV
2. Press the
ber with blinks. For example, if the number is 3, the light
will blink three times. In case of 0, the light will blink ten
times.
You can reset the settings by doing as follows:
1. Hold down the
more than five seconds.
2. Each device button blinks three times in the following
£
¢
order:
PVR
3. After that, all settings will be reset to the manufacturer's
factory settings.
NOTE
Some buttons may not work properly depending on a device.
If your device code is not listed on the following pages, you
will not be able to use this remote as a universal remote for
your specific device.
£
¢ ¡
and device button simultaneously
OK
£
£
¢ ¡
¢ ¡
and
OK TV
£
¡ ¢
or
CHANNEL
+
£
¢ ¡
and device button simultaneously
OK
button. Then the light will show the num-
£
£
¢ ¡ ¢ ¡
and buttons simultaneously for
TV 0
£ £
→ → →
¡ ¢ ¡
¢ ¡
DVD AUX
buttons simultaneously.
¡
button until the de-
£
¢ ¡
TV
£
¢ ¡
OK