At24C01A/02/04/08A/16A; Pin Description; Memory Organization - Harman Kardon HK3490 Service Manual

Hide thumbs Also See for HK3490:

Service manual (70 pages)

Owner's manual (32 pages)

Remote control manual (1 page)

100

101

102

103

104

105

106

107

108

Table Of Contents

109

Table of Contents

HK3490

Pin Description

Memory Organization

SERIAL CLOCK (SCL): The SCL input is used to positive edge clock data into each

EEPROM device and negative edge clock data out of each device.

SERIAL DATA (SDA): The SDA pin is bidirectional for serial data transfer. This pin is

open-drain driven and may be wire-ORed with any number of other open-drain or open-

collector devices.

DEVICE/PAGE ADDRESSES (A2, A1, A0): The A2, A1 and A0 pins are device

address inputs that are hard wired for the AT24C01A and the AT24C02. As many as

eight 1K/2K devices may be addressed on a single bus system (device addressing is

discussed in detail under the Device Addressing section).

The AT24C04 uses the A2 and A1 inputs for hard wire addressing and a total of four 4K

devices may be addressed on a single bus system. The A0 pin is a no connect.

The AT24C08A only uses the A2 input for hardwire addressing and a total of two 8K

devices may be addressed on a single bus system. The A0 and A1 pins are no

connects.

The AT24C16A does not use the device address pins, which limits the number of

devices on a single bus to one. The A0, A1 and A2 pins are no connects.

WRITE PROTECT (WP): The AT24C01A/02/04/08A/16A has a Write Protect pin that

provides hardware data protection. The Write Protect pin allows normal Read/Write

operations when connected to ground (GND). When the Write Protect pin is connected

to V

, the write protection feature is enabled and operates as shown in Table 2.

Table 2. Write Protect

WP Pin

Status

24C01A

Full (1K)

At V

Array

At GND

Normal Read/Write Operations

AT24C01A, 1K SERIAL EEPROM: Internally organized with 16 pages of 8 bytes each,

the 1K requires a 7-bit data word address for random word addressing.

AT24C02, 2K SERIAL EEPROM: Internally organized with 32 pages of 8 bytes each,

the 2K requires an 8-bit data word address for random word addressing.

AT24C04, 4K SERIAL EEPROM: Internally organized with 32 pages of 16 bytes each,

the 4K requires a 9-bit data word address for random word addressing.

AT24C08A, 8K SERIAL EEPROM: Internally organized with 64 pages of 16 bytes each,

the 8K requires a 10-bit data word address for random word addressing.

AT24C16A, 16K SERIAL EEPROM: Internally organized with 128 pages of 16 bytes

each, the 16K requires an 11-bit data word address for random word addressing.