Sony Ipela SSM-L24F1 Operation Manual page 3

Using a bracket
Front
10 (4)
Side
10 (4)
Consult with Sony qualified personnel for wall mount
installation.
7
25 (9 / )
8
10 (4)
7
25 (9 / )
8
Units: cm (inches)
WARNING: THIS WARNING IS APPLICABLE FOR USA
ONLY.
If used in USA, use the UL LISTED power cord specified below.
DO NOT USE ANY OTHER POWER CORD.
Plug Cap Parallel blade
(NEMA 1-15P Configuration)
Cord Type NISPT-2 or SPT-2, two 16 or 18 AWG wires
Length Minimum 1.5 m (4 ft 11 in), Less than 2.5 m (8 ft 3 in)
Rating Minimum 7A, 125V
Using this unit at a voltage other than 120V may require the use
of a different line cord or attachment plug, or both. To reduce the
risk of fire or electric shock, refer servicing to qualified service
personnel.
WARNING: THIS WARNING IS APPLICABLE FOR OTHER
COUNTRIES.
1. Use the approved Power Cord (2-core mains lead) / Appliance
Connector / Plug that conforms to the safety regulations of each
country if applicable.
2. Use the Power Cord (2-core mains lead) / Appliance Connector
/ Plug conforming to the proper ratings (Voltage, Ampere).
If you have questions on the use of the above Power Cord /
Appliance Connector / Plug, please consult a qualified service
personnel.
WARNING
1. Use the approved Power Cord (2-core mains lead) / Appliance
Connector / Plug that conforms to the safety regulations of each
country if applicable.
2. Use the Power Cord (2-core mains lead) / Appliance Connector
/ Plug conforming to the proper ratings (Voltage, Ampere).
If you have questions on the use of the above Power Cord /
Appliance Connector / Plug, please consult a qualified service
personnel.
For the customers in the U.S.A.
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the
interference at his own expense.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority to
operate this equipment.
All interface cables used to connect peripherals must be shielded
in order to comply with the limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
GB
3