Before You Call For Service - Monogram ZDT800I Owner's Manual

Questions?
PROBLEM
Use this Start status
indicator light
problem
flashing
solver
Dishwasher
BEEPS once
every minute
Display
shows "LEAK
DETECTED"
Beeping at
the end of
the cycle (on
some models)
Dishes and
flatware not
clean
Spots and
filming on
glasses and
flatware
POSSIBLE CAUSE
The door was opened or the
cycle was interrupted.
This is a reminder that your
dishwasher door has been left
open during operation. It will
continue beeping until you
press START and close the door.
Possible leak is detected
This is normal. The
dishwasher will beep twice at
the end of the cycle.
Ultra Fine or Fine filter is
clogged
Low inlet water temperature
Water pressure is temporarily
low
Air gap or disposer is clogged
Improper rack loading
Poor performing detergent
Leak detected
Extremely hard water
Low inlet water temperature
Overloading or improper
loading of the dishwasher
Old or damp powder detergent
Rinse agent dispenser empty
Too little or low performing
detergent

Before You Call for Service

Dishwasher
WHAT TO DO
• Press the START button once and close the door to start the
dishwasher.
• Press the START button a second time when the dishwasher is
running only if you wish to cancel the cycle.
• Press START and close the door.
• Some models are equipped with leak detection and the cycle
will be cancelled if a leak is detected. The display will show
"LEAK DETECTED". Call for service.
• To turn off the double beep indicator (or re-activate it if it was
previously turned off), press the Heated Dry button 5 times
within 3 seconds. A triple beep will sound to indicate the
end-of-cycle beep option has been turned on or off.
• See the Care and cleaning section.
• Make sure inlet water temperature is correct (see the Using the
dishwasher section). Turn on the hot water faucet nearest the
dishwasher, let run until the water temperature stops rising.
Then start the dishwasher and turn off the faucet. This ensures
the entering water is hot. Select Boost Temp.
• Turn on a faucet. Is water coming out more slowly than usual? If
so, wait until pressure is normal before using your dishwasher.
• Clean the air gap or flush the disposer.
• Make sure large dishware does not block the detergent
dispenser or the wash arms. See the Loading the dishwasher
section.
• Use a highly rated detergent such as Cascade
Pacs.
• Some models are equipped with leak detection and the cycle
will be cancelled if a leak is detected. The display will show
"LEAK DETECTED". Call for service.
• Use rinse agents such as Cascade
prevent spots and prevent new film buildup.
• If water is extremely hard, a softener may be required.
• Make sure water temperature is at least 120°F (49°C).
• Load dishwasher as shown in the Loading Place Settings
section.
• Make sure detergent is fresh.
• Refill with rinse agent such as Cascade
• Make sure you use the proper amount of highly rated detergent.
Platinum
®
Complete Rinse Aid to
®
Complete Rinse Aid.
®
23