American Standard Retrospect Collection Pedestal Sink 0066.000 Specifications

RETROSPECT COLLECTION
• Authentically styled rectangle pedestal
• Made from fine fireclay
• Generous deck area for toiletries
• Hidden front overflow
• Supplied with mounting kit
• Right Height™ for greater comfort
• Part of design matched Retrospect Collection
❏ 0282.800 Faucet holes on 8" (203mm) centers
Nominal Dimensions:
27" x 19-3/4" x 36"
(686 x 502 x 914mm)
Separate Components:
❏
0282.008 Pedestal top 8" (203mm) centers
❏
0066.000 Pedestal only
Bowl sizes:
15-1/2" (394mm) wide
12" (305mm) front to back
6-1/8" (156mm) deep
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• ASME A112.19.9M for Non-Vitreous
Ceramic Fixtures
• CAN/CSA B45 Series
To Be Specified:
❏ Color: ❏ White
❏ Recommended Faucet: 2373.701
❏ Faucet Finish:
❏ Supplies:
❏ 1-1/4" Trap:
© 2008 AS America Inc.
PEDESTAL SINK
®
®
RETROSPECT COLLECTION
13-3/4"
(349mm)
8"
(203mm)
FINISHED WALL
9"
(229mm)
1-3/4" DIA.
STD. DRAIN
OUTLET
27"
(686mm)
7-1/4"
(184mm)
8"
3/8" (10mm) DIA.
(203mm)
SINK ANCHOR
SCREW HOLES
ON 13-3/4" (349mm)
CENTRES
*
24"
(610mm)
*
22"
(559mm)
FINISHED
FLOOR
9-7/8"
(251mm)
NOTES:
DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND "P" TRAP ARE
*
SUGGESTED.
▼ PEDESTAL ANCHORING SCREWS NOT INCLUDED.
■ SUITABLE FOR REINFORCEMENT ONLY. ACTUAL DIMENSIONS MUST
BE TAKEN FROM FIXTURE.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL SUPPORTS.
INSTALLATION INSTRUCTIONS SUPPLIED WITH LAVATORY.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.9.
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided pages.
J8
PEDESTAL SINK
FIRE CLAY
3 Holes
1-3/8" (35mm) Dia.
3-3/8"
(86mm)
15"
(381mm)
19-3/4"
(502mm)
PED TOP
OUTLINE
8-1/8"
TO BOTTOM
OF DRAIN OUTLET
(206mm)
SUPPLIES
AS REQ'D
36"
1-1/4 O.D.
(914mm)
WASTE
28-1/4"
1-1/4" O.D.
(718mm)
TAILPIECE
PEDESTAL
3/8" (10mm) DIA.
SIDE SECTION
BASE ANCHOR
SCREW HOLE
CENTER
Revised 2/08
®