Mechanical Installation 2.4.5 Electrical Installation 2.4.6 Pin Assignment 2.4.7 Post Installation Checks Adjustments Accessories Required But Not Supplied Installation Drawings Operation Introduction General Information Installation and Operation Manual Page iii ENG-FORM: 820-0114.DOT CONFIDENTIAL AND PROPRIETARY TO NORTHERN AIRBORNE TECHNOLOGY LTD.
Outputs from the Model 247 are designed to drive any impedance from 8 ohms up to 10K ohms. Output power is limited by 100 ohm resistors on each output. If additional inputs are needed beyond the four inputs provided for each mixing circuit, an output from one mixer circuit can be fed to the input of another mixer thereby increasing the size of the mixer.
-55° to +70° C Altitude -15,000 to 70,000 feet Qualification of the Model 247 Audio Mixing Amplifier was completed in accordance with RTCA/DO-160C Env. Cat. [A2F2]-BA(CL)XXXXXXZ(BZ)AAATZ(XXC2)XX Note: Refer to Environmental Qualification Form located in Section 2 of this Manual for complete details of the environmental categories.
2.2.1 Warranty All Northern Airborne Technology Ltd. products are warranted for 2 years from date of installation by an authorized Northern Airborne Technology Ltd. dealer, to be free of defects in workmanship or performance. This warranty covers all materials and labour, but is exclusive of any transport to deliver the defective unit to and from Northern Airborne Technology Ltd.
Verify that the selected circuit breaker size and wire gauge are adequate for the installation using the techniques specified in AC43.13-1B Change 1, Paragraphs 11-47 through 11-51 and 11-66 through 11-69. Section 2 Rev: 1.00 Issue 2 Page 2-2 ENG-FORM: 805-0118.DOT CONFIDENTIAL AND PROPRIETARY TO NORTHERN AIRBORNE TECHNOLOGY LTD.
2.4.5 Electrical Installation The Model 247 has 3 separate power and ground inputs for each of its 3 internal mixer circuits. This is designed to allow maximum flexibility for the installer if separate power supplies are used. All three power and ground inputs can also be connected together and supplied from one source. Maximum current draw for each mixer circuit within the Model 247 is 0.5 Amps assuming maximum output voltage...
Internal Adjustments below. Refer to Assembly drawing 247-1 in the SM247 Maintenance manual. To remove the Model 247 cover, remove the 2 screws in the top of the unit. Do not remove screws under the base of the unit. Lift the cover to remove.
Page 15
24.0 Category X, no test performed REMARKS: Model 247-xxx was qualified to the environmental test requirements of RTCA DO-160C by similarity to Model 250-xxx - Tests of DO-160C, Sections 4.0 (paragraphs 4.5.1, 4.5.2, and.4.5.3), 5.0, 16.0 and 18.0 were conducted on the Model 250 at dB Systems, Inc. in Redmond, Washington.
SM247 Installation and Operation Manual Section 3 Operation Introduction Information in this section consists of the functional and operational procedures for the Model 247 Audio Mixing Amplifier. General Information The Model 247 Audio Mixing Amplifier has no operator accessible controls. During installation, it may be determined that internal level adjustments are required.
Need help?
Do you have a question about the 247 and is the answer not in the manual?
Questions and answers