Stay Alert Feature; Safety Warning System - Whistler XTR-475 Owner's Manual

OPERATION
Stay Alert Feature
The S"tay Alert Feature is designed to test a driver's
alertness. To engage (when the unit is not alarming) :
XTR-475
• Press and hold the City button for less then 2 seconds. A
compass heading icon will flash indicating Stay Alert is activated.
Within 30-60 seconds, two beeps are sounded; to show
alertness, the driver must press either the (Volume), City or Quiet
button within 3-5 seconds. If the button is pressed within 3-5
seconds, the cycle is repeated.
If a button is not pressed within 3-5 seconds, alarm sounds
and the display will flash all LEOs.
• Press Power to cancel Stay Alert.
XTR-500/550/555/575/580/590
• Press and hold the City button for approximately 2
seconds. Release the button during or immediately after
the alert is given. Display shows:
O":~U
RLEP
I)
Within 30-60 seconds, two beeps are sounded; to
show alertness, the driver must press either the City,
Menu, or Quiet buttons within 3-5 seconds. If a button is
pressed within 3-5 seconds, the cycle is repeated.
If a button is not pressed within 3-5 seconds, an alarm
sounds and the display shows:
(I;i:::
T
PE'-,T)
• Press the Dark button to exit the Stay Alert feature.
WARNING!!! Stay Alert is NOT intended as a substitute
for adequate rest. You should
NOT
operate a vehicle if you
are drowsy. During extended periods of vehicle operation,
you should take frequent breaks. Improper reliance on the
Stay Alert feature may result in vehicle damage, personal
injury or death. NEVER OPERATE A VEHICLE IF YOU
ARE DROWSY.
SWS™
Safety Warning System™
In communities where transmitters are located,
the Safety Warning System
T
'"
displays over 60 text
messages. When Safety Radar is detected, the audio
alert sounds like a geiger counter.
Safety Warning System Text
Example: Poor - Road - Surface.
Note:
Not all areas have Safety Warning System'''' transmitters.
15