Advertisement
Manual,Instructions & Parts List
PATIO HEATER
Natural Gas
WARNING: For Outdoor Use Only.
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. If odor continues ,immediately
Do not store or use gasoline or
other flammable vapors or liquids
in the vicinity of this or any other
appliance.
CAUTION: Retain the instructions
C E R T I F I E D
Model No.:SRPHN02
Master Contract No.:217109
Customer Item No.: PTHC38NK
FOR YOUR SAFETY
call gas supplier.
FOR YOUR SAFETY
for future use.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Shinerich SRPHN02
Summary of Contents for Shinerich SRPHN02
-
Page 1: Natural Gas
CAUTION: Retain the instructions for future use. C E R T I F I E D Model No.:SRPHN02 Master Contract No.:217109 Customer Item No.: PTHC38NK Manual,Instructions & Parts List... - Page 2 TOOLS AND PARTS NEEDED FOR ASSEMBL Y TOOLS AND PARTS NEEDED FOR ASSEMBL Y WARNING: Improper installation, TOOLS NEEDED: adjustment, alteration, service or 7/16 Wrench maintenance can cause injury, death or 3/8 Open End Wrench property damage. Adjustable Opening Wrench, 8 Long Read the installation, operating and Philips Head Screwdriver maintenance instructions thoroughly...
- Page 3 PARTS Centre Reflector Cap Reflector Cap Head Assembly Upper Post Mid Post Lower Post Base M8 x55 Bolts 8mm Washers 8mm Spring Washers M8 Nuts 15 M6 Nuts 18 6mm Washers 12 M6x10 Bolts M6x70 double pointed bolts 1 Gas Hose...
- Page 4 PRECAUTIONS NOTE: PLEASE READ THE FOLLOWING SAFETY RULES WARNING This appliance must only be used outdoors. Always assure there is ample fresh air ventilation. Using this product in an enclosed area may cause For outdoor use ONLY . injury, death or property damage. Do not clean the heater with cleaners that are combustible Read the instructions before use.
- Page 5 ASSEMBLY FOR LIGHT SYSTEM WARNING: TO BE INSTALLED ONLY BY AN AUTHORISED PERSON Ignition button Instruction For Battery Installing Upon first time use of the product,please remove the Control knob ignition button and install an AA battery as indicated. Replace Battery Ignition button AA battery...
- Page 6 ASSEMBLY NOTE: Assembly of this heater requires Step 1 basic mechanical skills. Proper assembly is the responsibility of the installer. Step 1 ---- Assembly for lower post Attach lower post to base Place the lower post on the top of base.Then connect them using 4pcs M8*55 bolts,4pcs 8mm washers,4pcs 8mm spring washers...
- Page 7 ASSEMBLY NOTE: Assembly of this heater requires basic mechanical skills. Proper assembly is the responsibility of the installer. Step 3 Step 3 ---- Attach upper post to mid post Turn the upper post clockwise to the mid post as illustrated until tighten them securely.
- Page 8 ASSEMBLY NOTE: Assembly of this heater requires basic mechanical skills. Proper assembly is the responsibility of the installer. Step 5 Step 5 ---- Route hose through opening i n c y l i n d e r b a s e . Step 6 ---- Attach Double Pointed Bolt to Step 6 H e a d...
- Page 9 ASSEMBLY NOTE: Assembly of this heater requires basic mechanical skills. Proper assembly Step 7 is the responsibility of the installer. Step 7 ---- Attach Center Reflector to Reflector Attach center reflector to the top of reflector (4 pcs) by M6 X 10 mm screws (12 pcs) , 6mm washers (12 pcs) and nuts (12 pcs).
- Page 10 Attach Gas hose to Natural Gas with Quick disconnect device. Step 10 Step 10 ----Check for leak Your Patio Heater has been checked at all factory connections for leaks,To check the Connection of the gas hose/natural gas pipe. 1)Make leak solution by mixing 1 part liquid dish soap and 3 parts water.
- Page 11 ASSEMBLY WARNING: TO BE INSTALLED ONLY BY A Step 11 COMPETENT PERSON Step 11 ---- Disconnect Natural Gas When Storing or Transporting 1).Turn off the heater. 2).Turn off the valve of natural gas. 3).Disconnect the gas hose.
-
Page 12: Before Lighting
OPERATION WARNING: DO NOT attempt to operate heater until you have read and understand all precautions. WARNING Failure to do so can result in serious personal injury, death or property damage. FOR YOUR SAFETY: If at any time you are unable to light burner Before Turning Gas Supply ON and smell gas,wait 5 minutes to allow gas Your heater was designed and approved for OUTDOOR USE ONLY. -
Page 13: Operation
OPERATION OPERATION CAUTION Avoid inhaling fumes emitted from the heater's first use. Smoke and odor from the burning of oils used in manufacturing will appear. Both smoke and odor will dissipate after approximately 30 minutes. The heater should NOT produce thick black smoke. NOTE: The burner may be noisy when initially turned on. - Page 14 LOCATING HEADER FOR USE BE CAREFUL: WHEN CERTAIN MATERIALS OR ITEMS ARE LEFT UNDER THIS SPACE HEATER WHILE IN USE, THEY WILL BE SUBJECT TO RADIANT HEAT AND COULD BE 36" SERIOUSLY DAMAGED. This heater is primarily used for the 24"...
-
Page 15: Replacing Injector
REPLACING INJECTOR Step 1 1.Remove the reflector and emitter by removing the 4 pcs screws( that fasten the emitter to the lower screen cone. Emitter Screen Lower 2.Remove lower cone cylinder by removing the 4 pcs screws( Cone which attach the lower cone cylinder to the control cylinder. Cylinder Control Cylinder... - Page 16 REPLACING INJECTOR 4.Use the spanner to take down the old injector, assemble the exchanged injector,and screw it by spanner. The picture for pilot flame gas tube exchanged 6.4 Aluminum pipe.
-
Page 17: Maintenance
MAINTENANCE Check Your Hose Assembly: The installation of fixed appliances shall only be carried out by competent persons and be in accordance with the relevant Codes of Practice. Visually check Warning: This appliance requires a gas hose and natural gas pipe, check with your gas supplier and or product supplier. - Page 18 STORAGE STORAGE : Between uses: Turn the control knob to "OFF" position. Turn natural gas to "OFF" position. NOTE Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris). Wait until heater is cool before covering.
-
Page 19: Troubleshooting
TROUBLESHOOTING PROBLEM PROBABLE CAUSE SOLUTION Pilot will not light Gas valve may be OFF Turn the gas valve ON Fuel Tank empty Refill LP gas tank Orifice blocked Clean or replace Orifice Air in supply system Purge air from lines Loose connection Check all fittings Dead battery...
Need help?
Do you have a question about the SRPHN02 and is the answer not in the manual?
Questions and answers