Whirlpool ADG 130 Quick Reference Manual page 9

If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem.
Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation.
The appliance...
...is not working/will not start
...the CANCEL/Off indicator lamp
blinks 6 times
...the CANCEL/Off indicator lamp
blinks 6 times/wash program
ended too early (dishes are dirty
and wet)
...the CANCEL/Off indicator lamp
blinks 8 times
Possible causes...
- The appliance must be switched on.
- The dishwasher door doesn't close.
- "Delayed start" option is ON.
- Water tap closed.
- Kinked water inlet hose or clogged inlet
filters.
- Water pressure too low.
- Dirty or clogged filters.
- Too little water in the dishwasher's water
system.
- Drain hose incorrectly fitted.
- High level of foam inside.
- Dirty filters.
- Kinked drain hose.
- Syphon hose connection closed.
After taking the above course of action, the fault message must be reset. In the majority of cases the fault is thus eliminated.
RESET: Press the CANCEL/Off button.
Close the door.
Water drains automatically for up to 1 minute.
The appliance is now ready to be restarted.
- Check the household circuit fuse if there is no power supply.
- Check if the dishwasher's door is closed.
- Check whether the "Delayed start" option (if available) has been selected. If it has,
the appliance will only start once the set time has elapsed. If necessary, set the
delayed start to "0" (RESET the appliance).
- The water tap must be open.
- The water inlet hose must not be kinked and the relative inlet filter in the water
tap connector must not be dirty or clogged.
- The water tap must be fully open during water inlet (minimum capacity: 0.5 litres
per minute).
- The filters must not be dirty or clogged.
- Concave items (e.g. bowls, cups) must be arranged facing downwards in the rack.
- The drain hose must be fitted correctly (for high mounted appliances, leave min.
200-400 mm from the lower edge of the appliance) - see Assembly instructions.
- Repeat without detergent or wait until foam disappears.
- Clean the filters.
- The drain hose must not be kinked.
- The closure disk of the syphon hose connection must be removed.
What to do if...
Solutions...
GB -9-