Sony TRINITRON KV-G14L2J Service Manual page 21

Option Note
13. VPX bit 7
Item HCO
Initial data
HCO EHT Tracking Mode
EVG Enable Vertical Guard
SBL Service Blanking
PRD Over-voltage Protection Detection 1 = enable,
VID Video Ident Mode
3A. OP0 bit 7
Item No TOP
Initial data
AV Input 0 0 no AV input model
1 0 2 AV input model
No TOP (for teletext model)
AV MUT 1 = AV multi is always muted if no signal input, 0 = not muted always
Other optional bits are effective if set to 1.
3B. OP1 bit 7
Item
Initial data
XTAL SEL 0 0 only 4.43 XTAL
1 0 (not used)
1 V-Curve (for monaural model)
1 = using common volume curve for every mode and every TV system
0 = another volume curve available for video mode and M system
HDEV 1 = High Deviation Mode switch available,
Other optional bits are effevctive if set to 1.
3C. OP2 bit 7
Item
Initial data
No Bal. (for AV stereo model)
Other optional bits are effective if set to 1.
Hotel TV mode should be switched with remote commander from STBY condition as below.
Hotel TV on : push "display", "8", "vol +" and "power" sequentially
Hotel TV off : push "display", "8", "vol –" and "power" sequentially
bit 6 bit 5
EVG SBL
0 0 0
1 = on V and E–W, 0 = only on V
1 = enable, 0 = disable
1 = active, 0 = inactive
1 = not for ø1-loop, 0 = for ø1-loop
bit 6 bit 5
AV input
0 1 0
1 = only FLOF available, 0 = both FLOF and TOP available
bit 6 bit 5
– – HDEV
0 0 0
bit 6 bit 5
– – No Bal.
0 0 0
1 = no balance in analog select items,
bit 4 bit 3
PRD –
0 0
0 = disable
bit 4 bit 3
AVMUT B/G
0 1
0 1 1 AV input model
1 1 2 AV input and RGB input model
bit 4 bit 3
1 V-Curve XTAL SEL
0 1
0 1 only 3.58 XTAL
1 1 both 4.43 and 3.58 XTAL
0 = not available
bit 4 bit 3
TV Out Hotel
0 0
0 = balance included
– 21 –
KV-G14L2J/G21M2J
bit 2 bit 1 bit 0
– – VID
0 0 0
0A (7)
0A (6)
0B (7)
0B (6)
09 (7)
bit 2 bit 1 bit 0
I D/K M
1 1 1
bit 2 bit 1 bit 0
SECAM 2nd Lang.
1 1 1
bit 2 bit 1 bit 0
VM D.B.F.B. Thai Bil.
0 0 0
RM-869