Table of Contents
Advertisement
OPERATOR'S MANUAL
MightyLite 26cc Edger
UT50500/UT50901
(ALL VERSIONS)
Your edger has been engineered and manufactured to our high standard for dependability, ease of operation, and operator
safety. Properly cared for, it will give you years of rugged, trouble-free performance.
WARNING:
To reduce the risk of injury, the user must read and understand the operator's manual before using
this product.
Thank you for your purchase.
SAVE THIS MANUAL FOR FUTURE REFERENCE
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Homelite MIGHTYLITE UT50500
Summary of Contents for Homelite MIGHTYLITE UT50500
- Page 1 MightyLite 26cc Edger UT50500/UT50901 (ALL VERSIONS) Your edger has been engineered and manufactured to our high standard for dependability, ease of operation, and operator safety. Properly cared for, it will give you years of rugged, trouble-free performance. WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual before using this product.
-
Page 2: Table Of Contents
TABLE OF CONTENTS Introduction ... 2 General Safety Rules ...3-4 Specific Safety Rules ... 4 Symbols ...5-6 Features ...7-8 Assembly ...8-9 Operation ...10-12 Maintenance ...13-15 Troubleshooting ...16-17 Warranty ...18-20 Parts Ordering / Service ...Back Page INTRODUCTION This product has many features for making its use more pleasant and enjoyable. -
Page 3: Important Safety Instructions
IMPORTANT SAFETy INSTRUCTIONS DANGER – When using your edger trimmer, follow basic precautions. WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury. READ ALL INSTRUCTIONS Read the operator’s manual carefully. Be thoroughly famil- iar with the controls and the proper use of the equipment. -
Page 4: Specific Safety Rules
Use this edger for edging along sidewalks, driveways, flower beds, and similar areas. Do not use for any other purpose. Do not use the edger on or near graveled surfaces. Start engine carefully. Make certain all attachments are disengaged before attempting to start. Keep hands, feet, clothing, and the like away from blade and moving parts. -
Page 5: Symbols
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the product better and safer. SyMBOL NAME Safety Alert Symbol Read the Operator’s Manual Wear Eye and Hearing Protection Keep Bystanders Away Ricochet... -
Page 6: Symbols
To avoid serious personal injury, do not attempt to use this product until you read thoroughly and understand com- pletely the operator’s manual. If you do not understand the warnings and instructions in the operator’s manual, do not use this product. Call Homelite customer service for assistance. Page ... -
Page 7: Features
Wheel Diameter ...4 in. Wheel Width ... 1-1/4 in. PRIMER BULB cHOkE DIAL FUEL STARTER GRIP TANk TRIGGER LOck ON/OFF SwITcH FRONT REAR HANDLE HANDLE THROTTLE TRIGGER DRIVE SHAFT HOUSING kNOB EDGER GUARD DEBRIS FLAP BLADE wHEEL Fig. 1 Page ... -
Page 8: Features
KNOW yOUR EDGER See Figure 1. The safe use of this product requires an understanding of the information on the tool and in this operator’s manual as well as a knowledge of the project you are attempting. Before use of this product, familiarize yourself with all operating features and safety rules. -
Page 9: Attaching The Front Handle
NOTE: If the button does not release completely in the positioning hole, the shafts are not locked into place. Slightly rotate from side to side until the button is locked into place. Tighten the knob securely. WARNING: Be certain the knob is fully tightened before operating equipment;... -
Page 10: Operation
Recommended fuel: This engine is certified to operate on unleaded gasoline intended for automotive use. Mix Homelite Premium Exact Mix lubricant with gasoline according to the instructions on the package. If Premium Exact Mix lubricant is not available, use a high quality syn- thetic 2-cycle engine lubricant, mixed at 2.6 oz. -
Page 11: To Stop The Engine
USING THE EDGER See Figure . When using the edger, hold the unit with your right hand on the rear handle and your left hand on the front handle. Keep a firm grip with both hands while in operation. The edger should be held at a comfortable position with the motor about hip height. -
Page 12: Operation
ADJUSTING DEPTH OF CUT See Figures - . The depth of cut is determined by the distance from the bottom of the wheel to the tip of blade. To adjust the blade depth: Stop the engine. Disconnect the spark plug wire and move it away from spark plug. -
Page 13: Maintenance
LOwER FLANGE wASHER Remove the old blade from the edger shaft. Clean debris from the edger shaft and flange washers. Center the new blade on the upper flange washer, making sure the blade sits flat. Install the lower flange washer with the cupped hole away from the blade. -
Page 14: Spark Arrestor
Using a 1/2 in. socket wrench, turn the blade nut coun- terclockwise onto the edger shaft and tighten securely. NOTE: Always make sure the blade is correctly installed and securely fastened before each use. REPLACING THE DEBRIS FLAP See Figure 1. -
Page 15: Spark Plug
CLEANING THE AIR FILTER SCREEN See Figures 1 - 1. For proper performance and long life, keep the air filter screen clean. Remove the hex nut, wavy washer, flat washer, and choke dial cover. Brush the air filter screen lightly to clean. ... -
Page 16: Troubleshooting
Problem Engine will not start. Engine starts but will not accelerate. Engine starts but will only run at high speed at half choke. Engine does not reach full speed and emits excessive smoke. Engine starts, runs, and accelerates but will not idle. TROUBLESHOOTING Possible Cause No spark. - Page 17 Problem Lubricant drips from muffler. TROUBLESHOOTING Possible Cause Operating edger at part throttle. Check lubricant/fuel mixture. Air filter dirty. IDLE SPEED Page 1 Solution Operate edger at full throttle. Use fresh fuel and the correct 2-cycle lubricant mix. Clean air filter. Refer to Cleaning the Air Filter Screen earlier in this manual.
-
Page 18: Warranty
HOMELITE brand product. Proof of purchase will be required by the dealer to substantiate any warranty claim. All warranty work must be performed by a Homelite authorized service center. -
Page 19: Your Warranty Rights And Obligations
U.S. EPA standards for the first two years of engine use from the date of sale to the ultimate purchaser. Homelite Consumer Products, Inc., must warrant the emission control system on your non-road or small off-road engine for the period of time listed above provided there has been no abuse, neglect, or improper maintenance of your non-road or small off-road engine. -
Page 20: Warranty
3 in. x 5 in. card or standard postcard: your name, mailing address, phone numbers, email address, Homelite product(s) purchased with item number from package, and serial number for each product. Mail the card to: Homelite Consumer Products, Attn. Homelite Registration, 1428 Pearman Dairy Road, Anderson, SC 29625.To receive information on our company and products, please include the following statement on your... - Page 21 NOTES...
- Page 22 1-800-242-4672. Replacement parts can also be obtained at one of our Authorized Service Centers. • HOW TO LOCATE AN AUTHORIZED SERVICE CENTER: Authorized Service Centers can be located online at www.homelite.com or by calling 1-800-242-4672. • HOW TO OBTAIN CUSTOMER OR TECHNICAL SUPPORT: To obtain Customer or Technical Support please contact us at 1-800-242-4672.
Need help?
Do you have a question about the MIGHTYLITE UT50500 and is the answer not in the manual?
Questions and answers