Homelite UT10514/14 IN. 33CC Operator's Manual page 13

STARTING THE ENGINE
See Figures  - 11.
Starting the product differs depending on whether the engine
is cold or warm.
WARNING:
Keep your body to the left of the chain line. Never straddle
the saw or chain, or lean over past the chain line.
 Place the chain saw on level ground and ensure that no
objects or obstructions are in the immediate vicinity that
could come in contact with the bar and chain.
 Hold the front handle firmly with your left hand and put
your right foot onto the base of the rear handle.
To start a cold engine:
 Set the ignition switch to the RUN ( I ) position.
 Make sure the chain brake is in the run position by pulling
back on the lever/hand guard.
 Fully press and release the primer bulb 7 times.
 Pull choke lever all the way out to FULL position.
 While squeezing both the trigger release and throttle trig-
ger, push in the throttle lock button. Release the throttle
trigger. This latches the trigger for starting.
 When the temperature is above 50°F, pull the starter
grip until the engine attempts to start, but no more than
3 times. When the temperature is below 50°F, pull the
starter grip until the engine attempts to start, but no more
than 5 times.
OPERATION
Starter
grip
Fig. 6
Page 1
ignition SwitCh
in the run
poSition
primer BulB
Choke lever
Full Choke
halF Choke
run poSition
Fig. 7
run
poSition
Fig. 8
Fig. 9
Fig. 10