Cobra Marine MR HH125 Owner's Manual page 15

Advanced Operation
Operating Your Radio VHF Marine Radio Protocols
Intro Operation Customer
Assistance
To Recall a Stored Memory Location:
MEM Icon
1. Press the Memory/Escape button. The MEM icon will be
turned On.
2. Press the Channel Up or Channel Down button to select Customer
Installation
Assistance
the memory location. If a memory location has been
Secondary Icons
programmed, its associated channel will display on the
LCD. Your radio is now in Marine Standby mode on the
selected memory location.
To Exit Memory Location Mode:
Notice Caution
Press the Memory/Escape button to return the radio
to Marine Standby mode. The last channel used in Marine
Standby mode will now be displayed on the
LCD and the MEM icon will disappear.
To Erase Stored Memory Locations:
1. Press and hold the Memory/Escape button for two (2)
seconds. The memory location number will start flashing
and the MEM icon will be turned On.
2. Use the Channel Up and Channel Down buttons to
advance to the memory location you want to erase.
3. Press the Memory/Escape button to select the memory
location. The memory channel number will stop flashing
and the channel number will start flashing.
4. Use the Channel Up and Channel Down buttons to
change the channel to read "00" at the selected memory
location.
5. Press the Memory/Escape button to erase that memory
location.
Repeat steps 2 through 5 to erase as many additional
memory locations as you want.
6. Press and hold the Memory/Escape button for two (2)
seconds. This will return the radio to Memory mode.
7. Press and release the Memory/Escape button again
to return to Marine Standby mode.
24 English
Warranty
Warning
Advanced Operation
Operating Your Radio VHF Marine Radio Protocols
Intro Operation Customer
Assistance
Memory Location Scan Mode
Memory Location Scan
During Memory Location Scan mode, the radio will rapidly
scan through all programmed memory channels. Whenever
any activity is detected on a channel, the radio will stop the
Customer
Installation
Assistance
scan for 10 seconds to allow you to listen briefly on that
channel. It will then continue to scan unless you switch out
Secondary Icons
of Memory Location Scan mode.
NOTE
If there are fewer than two (2) memory locations
Notice Caution
programmed in the radio, the Memory Location
Scan option will not be available. At least two (2)
memory locations need to be programmed to
use the Scan button.
To Enter Memory Location Scan:
MEM/ESC Button
1. From Marine Standby mode, press the Memory/Escape
button.
2. Press the DUAL WATCH/SCAN button. The radio will
immediately begin to scan all pre-assigned memory
channels. The SCAN and MEM icons will show on the
LCD.
3. A signal on any channel will stop the scan for
10 seconds to allow you to listen to the traffic
Scan Button
on that location.
4. Press the Channel Up or Channel Down button
to resume scanning the Memory Location Scan
channels or to change the scan direction.
5. To EXIT Memory Location Scan mode, press the
DUAL WATCH/SCAN button again. The SCAN and MEM
icons will disappear from the LCD and the radio will
return to Marine Standby mode.
Warranty
Warning
Nothing Comes Close to a Cobra
25
®