LG WF-T857 Service Manual page 7

One Touch Type (NORMAL TAB WITHOUY THREAD & ONE TOUCH TYPE INLET HOSE.)
1
Separate Middle connector from Water Supply Hose
Separate Middle connector from the Water
Supply Hose by pulling the Pressing Rod and
the Pressing Handle that is attached to the
Water Supply Hose while pressing them.
2
Loosen the fixed nuts to connect the connector to the tap
Untighten the screw of the connector so that the tap can
be placed in the middle.
Note
In case the tap is large.
If the tap diameter is too large or is square,
open the 4 screw and take out the guide
plate and follow step 1.
3
Fixing Connectors to the Tap
Push the upper connector up till the rubber packing is in tight
contact with the tap.
Then tighten the 4 screws.
4
Fixing Upper Connector and Middle Connector
Remove the fixed sticker in between the Upper
and Middle Connectors.
Tighten the connectors by holding one connector
and twist middle connector to the right.
5
Connecting Middle Connector and Water Supply Hose
Press down the pressing rod of the Water
Supply Hose which was separated from middle
connector(refer to Step1) and then join it to
the middle connector.
6
Checking the water leakage
After connecting the hose, open the tap to
check for any water leakage.
In case of water leakage, close the tap and start
again from step 1.
If you skip step1, it may cause water leakage.
Conector
Middle connector
Medio
Guide plate
Placa Guía
Connector
Conector
Fixed sticker
Barra de Presión
Pressing rod
Water Supply Hose
Manguera de Suministro de Agua
7
Etiqueta Fija Fixed Stiicker
Manija de Presión
Pressing Handle
Barra de Presión
Pressing Rod
Water Supply Hose
Manguera de Suministro de Agua
Rubber packing
Empaque de Caucho
Screw Tornillo
Fixed sticker
Etiqueta Fija
Rubber packing
Empaque de Caucho
Connector
Conector
Conector
Conector
Connector
Middle
Medio
Conector
Middle
Connector
Medio
Etiqueta Fijada
Connector
Pressing handle
Manija de Presión