Connect The Drain Hose - LG WF-T857 Service Manual

Hide thumbs Also See for WF-T857:
Table of Contents

Advertisement

2-3. CONNECT THE DRAIN HOSE

For pump model
• Connect the drain hose to the
outlet of the drain pump located
at the rear of the washing
machine.
NOTE : • Never lay down the drain hose, as water will be discharged.
• Be sure the drain hose is properly routed so it will not kink or lift from the sink.
• The discharge height should be approximately 0.9~1.2m from the floor.
• Connect the drain hose adjusting the length of it not to be dropped. If drain hose is dropped the
drainage could be poor because of blockage in the hose.
For non - pump model
• Connect the drain hose to the outlet of the drain
located at the back side of the washing machine.
• Keep it downward while the washing machine is working.
• Ensure the hose is free from kinking.
• Do not install the washer where it is directly exposed to sunlight,
wind, rain etc.
• Plug the power cord of this washer into a properly installed
standard electrical outlet that is switched & earthed.
• Attach the clip to the drain hose.
And then push it toward the body
of the washing machine as
indicated by the arrow.
• Fix the drain hose with the clip.
And then push it toward the body as in the figure.
9
• Check that the drain hose is
hung up over the edge of the
laundry tub.
• Do not use an extension hose.
Hose
Guide
0.9~1.2m
Drain Hose

Advertisement

Table of Contents
loading

Table of Contents