LG WT-H800 Service Manual page 38

SNAP RING.
Loosen the 6 fixing screws on the stator.
(Lower upper position screws)
Check the direction of SNAP RING.
(The handle of snap ring is toward to rotor and stator.)
Preventing fallen the stator, tighten with one hand and
then loosen the last screw.
For assembly take care lead wire's state, it produce a
Hall Sensor
Stator Housing
Water Guide
noise and cut attach the rotor.
7) Replacement of Bearing housing asm
Loosen 14 Fixing screws on the Bearing Housing ASM
and pull up it.
37