Related Manuals for Alpermann+Velte GPS Receiver
Summary of Contents for Alpermann+Velte GPS Receiver
-
Page 1: Gps Receiver
Operating Manual Version: 1.7 November 8, 2000 TC Generator Option GPS Receiver (built-in) - Page 3 Operating Manual GPS Receiver (built-in) TABLE OF CONTENTS Page A1 COPYRIGHT GPS RECEIVER SPECIFICATIONS CONFIGURATION ANTENNA AND CONNECTION Specifications Mechanical Data...
- Page 4 Information in this publication replaces all previously published information. Alpermann+Velte Electronic Engineering GmbH assumes no responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use of the information contained herein.
-
Page 5: Specifications
Page 1 GPS receiver The GPS receiver is built into the Time Code generator. An active antenna is connected via a 50 Ω cable at a SMA female connector. It’s built-in pre-amplifier is supplied via the same cable. No passive antenna must be connected, as this normally causes a DC short circuit. - Page 6 Antenna and Connection The GPS receiver is connected to the antenna with a 50 Ω coax cable. The receiver has a SMA male connector, the antenna a TNC male connector. The TNC connector has a rubber protection against atmospheric exposure. The following cable types are available:...
- Page 7 Operating Manual GPS Receiver (built-in) Page 3 Specifications Type active Frequency 1575 MHz ± 2 MHz Gain, Zenith 3.5 dBic Gain, +10° -3.0 dBic Amplifier gain 26 dB Amplifier noise figure 2.5 dB (typ.) DC voltage 5 V DC DC current 25 mA (typ.)
Need help?
Do you have a question about the GPS Receiver and is the answer not in the manual?
Questions and answers