Acoustic Research ARW51 Installation And Operation Manual page 5

15. The apparatus shall not be exposed to dripping or splashing and that no objects
filled with liquids, such as vases, shall be placed on the apparatus.
16. Do not overload wall outlet. Use only power source as indicated.
17. Always leave sufficient space around the product for ventilation. Do not place
product in or on a bed, rug, in a bookcase or cabinet that may prevent air flow
through vent openings.
18. Do not place lighted candles, cigarettes, cigars, etc. on the product.
19. Care should be taken so that objects do not fall into the product.
20. The MAINS plug is used as the disconnect device and shall remain readily
operable.
21. Where there is more than one connection supplying HAZARDOUS VOLTAGES or
HAZARDOUS ENERGY LEVELS to equipment, a prominent marking, located
close to the entry point provided for a SERVICE PERSON to gain access to the
hazardous parts, shall be provided to indicate which disconnect device or devices
isolate the equipment completely and which disconnect devices can be used to
isolate each section of the equipment.
22. Use the Adaptor which we provided and do not replace them at discretion.
WARNING: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV
INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS
EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO
OPERATE THIS EQUIPMENT.
COMPLIANCE WITH FCC REGULATIONS: This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
This symbol indicates that this
product incorporates double
insulation between hazardous
mains voltage and user
accessible parts.
3