Volt Power Supply - Husky HSK037 User Manual

Portable ac/dc power system
Table of Contents

Advertisement

HSK037 ENG MANUAL 090105
8. After vehicle starts, turn the safety power swi t ch to off, remove clamps
(disconnect the frame or engine clamp first), followed by the battery
cable and replace them on the built-in clamp tabs. Squeeze the handles
and slide the clamp into position and release your grip.
C C C C A A A A U U U U T T T T I I I I O O O O N N N N : : : :
• If engine fails to start, leave ignition turned off and disconnect the negative (-)
clamp first, then the positive (+) clamp. Try again later – the engine may be
flooded.
• Recharge jump-start system after each use.
W W W W A A A A R R R R N N N N I I I I N N N N G G G G : : : :
• Always disconnect the engine or frame jumper clamp first; followed by the
battery jumper clamp.
• Never allow red and black clamps to touch each other or any common metal
conductor; this could cause damage to the unit and/or create
sparking/explosion hazard.
• There is a risk of releasing explosive gases when batteries are charged or
discharged. Ffailure to follow instructions may cause property damage,
explosive hazard, and/or personal injury.
• Always use protective eyewear when using this product: contact with battery
acid may cause blindness and/or severe burns.
• Keep out of children's reach.
• ALWAYS store battery clamps on built-in clamp holders when not in use and
never touch battery cl a mps together. This can cause dangerous sparks,
power arcing and/or explosion.
F F F F I I I I R R R R S S S S T T T T A A A A I I I I D D D D : : : :
• SKIN: If battery acid comes in contact with skin, rinse immediately with
water; then, wash thoroughly with soap and water. If redness, pain, or
irritation occurs, seek immediate medical attention
• EYES: If battery acid comes in contact with eyes, flush eyes immediately for
a minimum of 15 minutes and SEEK IMMEDIATE MEDICAL ATTENTION.
4. 12 VOLT PORTABLE POWER SUPPLY
1. Open the front panel cover latch. (See Figures 1A and 3.)
2. Insert the 12 Volt DC plug from the appliance into the receptacle on the
unit.
3. Turn on the appliance, and operate as normal.
CAUTION:
DO NOT USE UNIT TO OPERATE APPLIANCES THAT DRAW
MORE THAN 5 AMPS DC
Tabl e II bel o w shows the esti m ated 12 Volt DC operating time when using a
fully charged system.
H H H H U U U U S S S S K K K K Y Y Y Y ® ® ® ® P P P P O O O O R R R R T T T T A A A A B B B B L L L L E E E E P P P P O O O O W W W W E E E E R R R R S S S S U U U U P P P P P P P P L L L L Y Y Y Y a a a a s s s s a a a a 1 1 1 1 2 2 2 2 V V V V o o o o l l l l t t t t D D D D C C C C P P P P o o o o w w w w e e e e r r r r S S S S u u u u p p p p p p p p l l l l y y y y
Appliance
Cell phone
9/1/05
5:48 PM
Page 11
T T T T a a a a b b b b l l l l e e e e I I I I I I I I
Estimated Power Usage
(Watts)
1
Estimated Operating Time
(hours)
120
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents