Miele KDN 12623 S -1 Operating And Installation Instructions page 47

Refitting the handles
Please make sure you follow the
instructions below carefully when
you refit the handles. The door seal
will be damaged if the handle is
fitted incorrectly.
^ Loosely attach the handle to the
opposite side of the door with the two
front screws
Mounting plate
on the side of the door so that when the
door is closed it is flush with the side of
the appliance.
If this is not the case,
^ tighten both grub screws
suitable allen key until mounting plate
lines up correctly.
^ Then tighten all 4 screws
^ Slide the side section of the handle
into the guides on the mounting
plate until it clicks into place.
.
must be positioned
with a
.
Changing the door hinging
It is important to check that the side
section of the handle
come into contact with the door seal
when opening the door, as this
would damage the door seal
permanently.
If, after you have refitted the handle,
you find that the side section does
touch the door seal when the door is
opened:
^ Realign mounting plate
screws until the mounting plate
and the side section of the handle
are at the correct angle and the side
section does not touch the door seal
when the door is opened.
does not
with grub
47