Hdmi - Pioneer HTP-SB300 Operating Instructions Manual

06 Additional information
Problem
No sound from subwoofer. • The Dolby Digital or DTS source you are listening to may not have an
Noise during playback of a
cassette deck.
No sound is output or a
noise is output when
software with DTS is played
back.
During a playback search,
noise is output from a DTS
compatible CD player.
Can't operate the remote
control.
The display is dark or off.

HDMI

Symptom
No picture or sound.
36
En
Remedy
LFE channel.
• Switch the LFE ATT (LFE Attenuate) on page 24 to LFEATT 0 or LFEATT 10.
• Transmission qualities may vary due to the presence of obstacles or
reflective objects in the signal path. Try changing the position or
orientation of the subwoofer.
• The main unit and the subwoofer in this set act as a pair, and are
designed to recognize each other specifically. Signal transmission is not
possible when a main unit or subwoofer from another set is used.
• The subwoofer may not emit sound when playing music that lacks a
continuing low bass range.
• Perform pairing of the main unit and subwoofer (refer to page 7).
• Move the cassette deck away from your system, until the noise
disappears.
• Set the digital volume level of the player to full, or to the neutral position.
• Make sure the player's settings are correct and/or the DTS signal out is
on. Refer to the instruction manual supplied with the DVD player.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
• Replace the batteries (refer to page 19).
• Operate within 7 m, 30° of the remote sensor (refer to page 19).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Press DIMMER on the control repeatedly to return to the default.
Remedy
• If the problem still persists when connecting your HDMI component
directly to your monitor, please consult the component or monitor manual
or contact the manufacturer for support.