Installation; Using The Mower; Cable Holder; Before Starting - Stiga Multiclip Quick Manual

SYMBOLS
The following symbols can be found on the ma-
chine to remind you of the care and attention that
are required during use.
The symbols mean:
Warning! Read the Instruction Book and
Safety Manual before using the machine.
Warning! Keep onlookers away. Beware
of objects being flung out.
Warning! Keep hands and feet clear of the
cutting deck when the machine is running.
Warning! Before starting any repair work,
remove the spark plug cable from the
spark plugs.
IMPORTANT
Certain models do not have a throttle control. The
engine speed is set for optimal function and mini-
mal exhaust emissions.

INSTALLATION

HANDLE
Fold up the lower part of the handle.
Then attach the upper part of the handle. This is at-
tached with screws, washers and locking wheels
(fig. 1).
The handle has four different positions. Release
the catch with your foot and set the handle in de-
sired position (fig. 2).
1. For normal mowing.
2. For mowing under trees, bushes, etc.
3. Parking position.
4. Delivery and storage position. The handle takes
up less space if the knobs are released and the
handle folded up.
ENGLISH
PRO 46
Raise the upper part of the handle and place it be-
hind the machine. Fold up the lower part of the
handle and tighten the locking wheels A (fig. 3).
Then attach the upper part of the handle. There is
also a lug on the right hand side for the starter han-
dle (fig. 1).
Storage position: Release the locking wheels on
the lower part of the handle and fold it forwards.
Then release the locking wheels on the upper part
of the handle and fold it backwards (fig. 4).
NOTE! Check that the wires are not caught or bro-
ken when the handle is unfolded or folded.

CABLE HOLDER

Attach the wires to the cable holder (fig. 5).

USING THE MOWER

BEFORE STARTING

FILL THE CRANKCASE WITH OIL
The lawnmower is delivered without
any oil in the engine crankcase. The
crankcase must be filled with oil before
the engine is started for the first time.
Remove the oil dipstick (fig. 6, 7).
Fill the engine's crankcase with 0.55 litres of good
quality oil (service class SE, SF or SG). Use SAE
30 or SAE 10W-30 oil.
Slowly fill to 'FULL/MAX'. Do not overfill.
CHECK THE OIL LEVEL
Check before using the machine that the oil level is
between 'FULL/MAX' and 'ADD/MIN' on the
dipstick (fig. 6, 7). The mower should stand level.
Remove and wipe off the dipstick (fig. 6, 7). Slide
it down completely and tighten it. Unscrew and
pull it up again. Read off the oil level. If the oil lev-
el is low, fill with oil up to the 'FULL/MAX' mark.
GB