Optoma ML300 Service Manual page 36

3. LED Calibration
Note:If the color abnormal, you can do the the "LE� calibration" .
Procedure (1)- Please press "Up"->"Home"->"Down"->"Zoom" of
remote controller to get into Service Mode.
- Press "Enter into LED Calbration"
- Press "O" of remote controller to start calibration
and "Fail" will appear in right blank,it means it has
return to default value.
Note:System Firmware C04 will phase in this
function.
(2) - Put the CL200 on the center of the screen
- Connect LED Calibration Fixture
and Projector by VGA Cable.
- Connect LED Calibration Fixture and CL200 by
CL200 RS232 Cable(42.8�50�.001).
- Connect LED Calibration Fixture and Computer
by USB Cable.
- Power on the projector and get into Service Mode
- Press "Enter into LED Calbration"
- Press "LED Calibration" to start calibration and
"finish" will appear in right blank.
Must be on the center of the screen
Computer
VGA Cable
ML300
Confidential
CL200 RS232 Cable
�SB Cable
CL200 RS232 Cable
4-0