Table of Contents
Advertisement
setup screen
to Set BLc
You can specify a desired area on the video manually and set the area to be displayed
more clearly.
1. Select <Back light>.
2. Set <mode> to <BLc>.
3. Set <BLc level>.
You can change the level to adjust the
brightness of the monitoring area.
4. Set the <top, Bottom, Left, right>
levels to specify the target area.
When BLC is set, the green box is
`
J
displayed on the screen for 15 seconds.
To prevent malfunction at the time of BLC setup, the vertical space of the BLC area should be over
`
40 and below 60 while the horizontal space over 30 and below 60.
to Set wDr
It displays a sharp image of the objects in a scene where both bright and dark areas exist.
1. Select <Back light>.
2. Set <mode> to <wDr>.
3. Specify the <wDr level>.
It is recommended to use WDR in the
`
J
indoor environment.
Noise may exist between the dark area
`
and the bright area in the WDR mode.
If the <Back light> mode is set to
`
<WDR>, the sensor mode cannot be set to 50 fps or 60 fps.
The maximum and minimum shutter values are initialized whenever you turn on or off the WDR
`
mode.
In case of SNB-6003/SNB-6004, some of the WDR functions may be restricted when the manual
`
or P-iris lens (manual) is used.
80_ setup screen
Advertisement
Table of Contents
