Advertisement
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
Your new Infiniti by Conair
Haircut Kit has every-
®
thing you need to achieve professional haircuts, at
home. It's 100% stainless steel blade provides longer
lasting performance and is sharpened using 3D
etching process for an exceptional cutting edge. Also
included are: 1 cutting guide for 28 various lengths
(3 to 30mm, in 1mm increments), 1 precision guide
provides 5 different positions (.5 to 2.5mm), thinning
system, on/off button, LCD display for selected length,
power level, battery charge level, charging stand,
adaptor cord, scissors, comb, cleaning brush, lubricat-
ing oil, barber cape, neck brush and 3 styling clips.
CHARGING THE CLIPPER
Before using the clipper for the first time, make sure
clipper is in the off position and charge for 2 hours.
The charging cord can be put in the stand. (Fig. 1)
Fig.1
Fig.2
1. Plug the adaptor into the AC outlet.
2. Place the clipper in the stand.
3. When fully charged, you will be able to use the
clipper for up to 45 minutes.
USING DIRECT PLUG-IN
Plug the end of the line cord into the clipper and plug
adaptor into an AC outlet. (Fig. 2) (If the battery is very
weak, wait about 1 minute, then turn on clipper).
USING THE COMB GUIDES
IMPORTANT: Always attach the comb guide BEFORE
turning the clipper on, and turn the clipper off to
change guides.
The comb guide is
Fig.3
very practical and
guarantees an even
cut.
To attach a comb
guide, first adjust the
cutting guide length
to 3mm on the LCD
display and push the
guide down until you
hear a "click". (Fig. 3)
STARTING AND USING
Push the ON/OFF button. The comb guide is automati-
cally put in its 3mm position.
The cutting length can be set using the 2 buttons with
arrow pointing up/arrow pointing down. Pressing one
of these two buttons will stop the motor and move the
comb guide. Once the cutting length is selected, press
the ON/OFF button again to confirm the length and to
restart the motor.
SWITCH SETTINGS
MOTOR MANAGEMENT SYSTEM
The exclusive Motor Management System
automatically senses when cutting especially "thick"
areas of hair and will increase power to easily cut
through these tough parts. The power level indicator
shows the power increase.
TO TURN THE CLIPPER OFF
Press the ON/OFF button for more than
2 sec
onds, the unit will shut down completely and
the comb guide will return to its original position; or
press the ON/OFF button for less than 2 seconds,
4 position setting: low/high/auto with motor manage-
ment off-only the mortor will turn off, the display will
remain lit for 15 seconds. After 15 seconds you will
still have 5 minutes to change the cutting length.
After 5 minutes, the
Fig.4
clipper turns itself off
and the cutting guide
remains in the posi-
tion last used.
To remove the comb
guide, first adjust the
cutting guide length
to 3mm on the LCD
display and push the
guide up using your thumbs and holding it on either
side. (Fig. 4)
CUTTING TECHNIQUES AND ADVICE
FROM THE EXPERTS
• Use the clipper on clean, dry hair.
• To familiarize yourself with the clipper, begin with
the comb guide for a longer cut, then, if you want
a shorter cut, lower the comb guide. You will soon
know the lengths of each cutting guide setting
from 3mm to 30mm.
TM
TM
Advertisement
