Advertisement
cord while it is hot or plugged in. Use the
stand provided.
12. Unplug this appliance before filling or
emptying. Do not overfill.
13. While emitting steam, this appliance may
cause burns if it is used too close to the
skin, scalp or eyes, or if it is used incor-
rectly. To reduce the risk of contact with
hot water discharging from steam vents,
test appliance before each use by holding
it away from body.
14. Do not operate steamer without properly
filling the water tank.
15. Always keep the hose and nozzle
elevated above the water tank.
16. Never yank cord to disconnect from
outlet. Instead, grasp plug and pull to
disconnect.
17. Burns could occur from touching hot
metal parts, hot water, or steam. Use
care when removing water tank or when
you turn a steam appliance upside down
– there may be hot water in reservoir.
18. To reduce likelihood of circuit overload,
do not operate another high-wattage
appliance on the same circuit.
19. If an extension cord is absolutely
necessary, a 15 ampere rated cord
should be used. Cords rated for less
amperage may overheat. Care should be
taken to arrange the cord so that it can-
not be pulled or tripped over.
20. Always remove the water tank from the
appliance before filling it with water.
21. When changing attachments, please be
sure the unit is off and no steam is being
released in order to avoid contact with
hot water.
22. Use caution when changing attachments,
as they may contain hot water from con-
densation. Ensure the attachments are
dry or cooled off, to avoid contact with
hot water.
SAVE THESE
INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
UNPACKING INSTRUCTIONS
Place the box on a large, sturdy flat surface.
Carefully remove the appliance from the
packing material. Keep all plastic bags away
from children.
STEAMER ASSEMBLY
Attaching the Telescopic Pole and
Rotating Hanger
Insert the bottom of the larger metal tele-
scopic pole into the holder on the unit base
and screw the set screw until tight. (Caution:
Do not over-tighten.)
Extend the telescopic pole and hang the
steam nozzle from the rotating handle. Hose
may be stiff upon removal from box. Hose
will relax after initial use.
Handle will sit properly on
pole support once hose is
relaxed.
TURNING STEAMER ON
1. Push the On/Off switch "I"
(ON) base of unit to On – red
light will go on (A).
2. The unit will heat up in
approximately 100 seconds
A
B
Advertisement
