Shine Specifications And Other Information; Battery; Water Resistance; Environmental Conditions - Misfit SHINE User Manual

Activity monitor
Hide thumbs Also See for SHINE:
Table of Contents

Advertisement

Shine Specifications and Other Information

Battery

Shine is powered by a 3 Volt CR2032 coin cell battery (included). It lasts about 4 - 6 months with
normal use.
When you see this low battery indicator:
to the app, you have less than one week to replace the battery. We recommend using the same
brand (or one with equivalent quality), which should give you the estimated battery life.
Battery replacement instructions:
1.
Firmly push the battery tool into
the notch until the cover lifts.
[Refer to Getting Started > Installing the Battery to re-assemble Shine]
Best practices to maximize Shine's battery life:
- Keep the app up to date
- Keep Shine's firmware up to date
- Resist unncessary tapping of SHINE as a party trick
CR2032 battery info: 3V Li-MnO2 225mAh
Operating temperature range: -22° to 140° F (-30° to 60° C)
[Review the Disposal and Recycling section for proper battery handling after use and Important Safety Warnings > Battery
Precautions for more safety information]

Water Resistance

Shine is water resistant up to 5atm (50 meters, 165 feet).
Suitable for dishwashing, splashing and swimming in shallow waters, not snorkeling or diving.
To maintain water resistance:
- Install the back cover correctly
- Do not tamper with the back cover when it is still submerged in liquid
- Avoid prolonged exposure to salt water or other chemicals, e.g. detergent, chlorine
- Avoid moving Shine in and out of contrasting extreme atmospheres; saunas, steam rooms, hot
tubs and hot showers could distort the sealing gasket
- Avoid opening the back cover unnecessarily
- When opening the back cover to replace the battery, avoid touching the gasket
- Never leave Shine open for more than a few hours; a dry gasket will cause the seal to fail

Environmental Conditions

Operating temperature: -4° to 122° F (-20° to 50° C)
Non-operating temperature: -22° to 140° F (-30° to 60° C)
on the upper left hand corner after you sync Shine
2.
30
o
Use the Clasp magnet to help you remove
the battery from the back cover.
15

Advertisement

Table of Contents
loading

Table of Contents