Using Your Btc; Battery Charging And Usage; Battery Charging; Battery Information - Vivanco BTC 700 User Manual

2. Using Your BTC 700

2.1 Battery Charging and Usage

2.1.1 Battery Charging

This device contains a rechargeable Li-Polymer battery. First-time charging time is about 4
hours. Later-on recharging time is around 2-3 hours. Detailed charging procedures as
follows:
1. Connect the car charger to the cigarette lighter.
2. Plug the USB Cable in PC.
3. Referring to Figure 3, plug the connector of the charger to BTC 700's charging port
to start charging. Both the Red and Blue LEDs will be on during charging. Once the
Red LED turns off, the battery is fully charged and you should disconnect the
charger from the BTC 700 and the power outlet.
Figure 2: Battery Charging
Note:
1. It is recommended to charge your device when it is not in use.
2. Please note that "inserting" charger will cause a device reset. When the device is in
charging (the charger has been inserted), the device is in normal operation.
3. During a call, the existing connection between the device and the mobile phone will
be reset after "inserting" the charger. The call will be transferred back to the mobile
phone momentary. The device will try to re-establish the connection automatically.
Sometimes, the user needs to short-push K2 to reconnect the device.

2.1.2 Battery Information

1. Once fully charged, the battery for BTC 700 supports continuous talk time up to 10
hours and standby (i.e. the device is power on but without connection) time about
900 hours.
7