Advertisement
OPERATING INSTRUCTIONS
Your heater is equipped with a technologically advanced 1 Touch
electronic thermostat. You can set the heater to run continuously
in manual mode or set the 1 Touch
temperature setting. The 1 Touch
turn the heater ON or OFF depending on the preset comfort level.
The comfort level ranges between 60º and 80º Fahrenheit.
Manual Mode Instructions:
1. Plug the heater into a 120V AC electrical outlet.
2. To start the unit, push the MODE/OFF button once for the HIGH (1500
Watts) manual setting. (See fig. #1 and #2)
3. Press the button again for the LOW (1000 Watts) manual setting. (See
fig. #1 and #2)
4. To stop the unit, press and hold the button for two seconds or keep press-
ing the button until all the temperature indicators are OFF.
Note: The Power Light will remain lit during operation. In Manual Mode,
only the LOW or HIGH power light will be lit.
TM
1 TOUCH
THERMOSTAT INSTRUCTIONS
To take advantage of the 1 Touch
MODE/OFF button until the desired temperature is set in either the HIGH
(1500 Watt) or LOW (1000 Watt) setting. When ambient temperature rises
above the set temperature, the heater will stop. When the ambient tempera-
ture drops below the set temperature, the heater will turn on automatically.
Note: When the 1 Touch
thermostat is set, either the HIGH or
TM
LOW power light, and the set temperature light will remain lit
during operation. (See fig. #1 and #2)
Note: It is normal for the heater to cycle ON and OFF as it maintains the
preset temperature. To prevent the unit from cycling, you need to raise the
thermostat setting.
Note: 1 Touch
TM
has memory. The 1 Touch
previous temperature setting after the unit has been turned off. However, if
the unit is unplugged, the 1 Touch
longer remember the previous temperature setting.
Note: This unit is equipped with a thermister located on the power
cord. This thermister is never to be tampered with in any way. It is
responsible for reading temperatures and adjusting the thermostat
accordingly. It will be most accurate when placed away from any
heat source.
CLEANING/MAINTENANCE
During Season Care:
Always unplug the heater, before moving or cleaning.
1. Carefully wipe the unit with a soft, damp cloth. Please be
very cautious near the motor and heating elements.
2. After cleaning, be sure to completely dry the unit with a
cloth or towel.
TM
TM
Thermostat to your desired
TM
thermostat will automatically
Thermostat continue to press the
TM
TM
thermostat will remember the
thermostat will be reset and will no
TM
After Season Care:
1. Store heater in a cool, dry location.
2. Holmes recommends that you store the unit in its original carton.
TROUBLESHOOTING
If your heater fails to operate:
• Make sure the electrical outlet or circuit breaker is working.
• Check for obstructions. If you find an obstruction turn the heater OFF, and
UNPLUG THE UNIT. Carefully remove the obstruction and follow the reset
instructions.
• The thermostat might be set too low. Press the MODE/OFF button until the
heater restarts.
Please DO NOT attempt to open or repair the heater.
Please see the Warranty for Service Instructions.
TECHNICAL SPECIFICATIONS
• Wattage: 1500 W (+5% -15%)
• Working Voltage: 120 V AC/60 Hz
ILLUSTRATIONS
Figure 1
Figure 2
MODE/OFF Button
Power Lights
Carry Handle
(not visible)
Caution Light
Thermister
(on power cord--
not visible)
Temperature Setting
Power Setting
/Off
Hide quick links:
Advertisement
