Making Connections - Tascam CD-BT1mkII Owner's Manual

Making connections

Connecting a bass guitar (BASS
IN)
BASS GUITAR
 Connect a bass guitar to the
IN jack.
 Set the BASS IN switch to either
PASSIVE or ACTIVE
the unit according to the type of
your bass guitar.
 The BASS IN jack of the CD-
BT1MKII accepts unbalanced
input signals. Use a ¼ inch mono
phone plug.
Adjusting the input level
Use the INPUT control to adjust the
level of the input signal from the
IN jack.
12
— TASCAM CD-BT1MKII
Inputting signals from external
devices (
 The LINE IN
mini-jack plug (3.5mm).
 The input level at the
cannot be adjusted on the CD-
BT1MKII, so adjust the output
level on the external device you
have connected.
BASS
LINE OUT OF EXTERNAL DEVICE
at the side of
WARNING
NEVER connect a bass guitar amplifier to the
CD-BT1MKII's
damage your equipment if you do this.
BASS
)
LINE IN
jack accepts a stereo
LINE IN jack
BASS IN
jack, as you will
Adjusting the output level after
adding built-in effects
Press and hold down the
EDIT key to open the Effect menu, and
press the NEXT or PREV key to choose
and use the UP and DOWN
LVL
set the output level between 0 and 64.
Adjusting mix balance between
bass guitar and CD
Press and hold down the
SETUP key to open the Setup menu,
and press either the NEXT
to choose . You can set the mix bal-
MIX
ance using values between B (Bass) 10
– B1, 0, C (CD) 1 – C10.
EFFECT/
keys to
TUNER/
or PREV key