Maintenance - MULTIQUIP Mikasa Series MVH306ds2 Operation And Parts Manual

CauTiOn
Inspection and other services should always be carried
out on hard and level ground with the engine shutdown.
inspection and maintenance service Tables.
To make sure your plate compactor is always in good
working condition before using, carry out the maintenance
inspection in accordance with Table 5 thru Table 7.
Table 5. mvh-306ds2/dsCpas machine inspection
item
Loose or Missing Screws
Damaged Parts
Function of Controlling
System Part
Hydraulic System Leak
Vibrator Oil Check Every
Vibrator Oil Replacement
Hydraulic Oil Check Every
Hydraulic Oil Replacement
V-belt (clutch) Check
Battery Check
CauTiOn
These inspection intervals are for operation under
normal conditions. Adjust your inspection intervals
based on the number hours plate compactor is in use,
and particular working conditions.
NOTICE
Fuel piping and connections should be replaced every
2 years.
page 24 — mvh306ds2/dsCpas pLaTe COmpaCTOR • OpeRaTiOn and paRTs manuaL — Rev. #7 (02/04/14)
hours of Operation
Every 8 hours (every day)
Every 8 hours (every day)
Every 8 hours (every day)
Every 100 hours
Every 100 hours
Every 300 hours
Every 100 hours
First after 200 hours, then every
1,000 hours
Every 200 hours
Every 100 hours
Table 6. mvh-306ds2/dsCpas engine Check
item
Oil or Fuel Leak
Tightness of Fastening
Threads
Engine Oil Check and Re-
plenishment
Engine Oil Replacement
Air Filter Cleaning Every
See separate engine manual for details on engine check.
daily service
„ Check for leakage of fuel or oil.
„ Check for loose screws including tightness. See Table 7
below (tightening torque ), for retightening:
Table 7. Tightening Torque
(in. kg/cm) diameter
Material 6mm 8mm 10mm 12mm
4T 70 150 300
6-8T 100 250 500
11T 150 400 800
300~ 650~
* 100
350 700
* (In case counter-part is of aluminum)
(Threads in use with this machine are all right handed)
Material and quality of material is marked on each bolt, and screw.
„ Remove soil and clean the bottom of compaction plate.
„ Check hand pump, piping and hose for any leakage. A
loosened hydraulic hose can be a cause for leakage.
Check hydraulic hose connections with wrench applied
for tightness.
„ Check engine oil.

MAINTENANCE

hours of Operation
Every 8 hours (every day)
Every 8 hours (every day)
Every 8 hours (every day) (Re-
plenish to specified maximum
level)
After first 25 hours then every 50
to 100 hours
100 hours
14mm 16mm 18mm
500 750 1,100 1,400 2,000
800 1,300 2,000 2,700 3,800
1,200 2,000 2,900 4,200 5,600
20mm